hama 00176590 WiFi Smart Alarm Siren Instruction Manual

: June 13, 2024
: Hama

Extended usage optionhama 00176590 WiFi Smart Alarm Siren Instruction Manual

Link to App

https://link.hama.com/app/smart-home

Operating Instructions

Controls and displays

A: Front

LED
Micro-USB socket

B: Reverse
Pairing button

Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

Package contents

1 WiFi siren with USB cable
1 adhesive pad
1 screw
1 plug
1 quick reference guide

Safety instructions

The product is intended for private, noncommercial use only.
Use the product only for the intended purpose.
Protect the product from dirt, moisture and overheating and use it in dry rooms only.
The product is intended only for use inside buildings.
Only use the article under moderate climatic conditions.
As with all electrical products, this device should be kept out of the reach of children.
Do not operate the product outside the power limits given in the specifications.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not drop the product and do not expose it to any major shocks.
Do not open the product or continue to operate it if it becomes damaged.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Route all cables so there is no risk of tripping.
Do not bend or crush the cable.
Always pull directly on the plug when disconnecting the cable, never on the cable itself.
Do not modify the product in any way. Doing so voids the warranty.
Keep the packaging material out of the reach of children due to the risk of suffocation.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.

Warning – Batteries

When inserting batteries, note the correct polarity (+ and – markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
Only use batteries (or rechargeable batteries) that match the specified type.
Before you insert the batteries, clean the battery contacts and the polarity contacts.
Do not allow children to change batteries without supervision.
Do not mix old and new batteries, or batteries of different types or from different manufacturers.
Remove the batteries from products that are not being used for an extended period (unless these
are being kept ready for an emergency).
Do not short-circuit batteries.
Do not charge batteries.
Do not burn batteries.
Keep batteries out of the reach of children.
Never open, damage or swallow batteries or allow them to enter the environment. They can contain toxic, environmentally harmful heavy metals.
Remove spent batteries from the product and dispose of them without delay.
Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric pressures (such as at high altitudes).

Warning – Danger of damage to hearing from alarm sound

Loud volumes can damage hearing – even over short periods.
Be aware that the high sound pressure of the signal sound emitted in the event of an alarm or test can lead to hearing damage in the short term.
You should therefore not remain in the immediate vicinity of the alarm signal emitter for more than 3 minutes in the event of an alarm or test.

Here’s how easy it is Download the app

Download the Hama Smart Home app from the Apple App Store or Google Play Store.
Open the Hama Smart Home app.
The first time you use the app, you need to register and create a new account. If you already have an account, log in with your access details.
Follow the instructions in the app.

Note
A detailed description of the Hama Smart Home App and its full scope of functions can be found in our App Guide at:

www.hama.com < Article Number >Downloads > App Operating Instructions

Installation

Warning – installation with adhesive

All parts are suitable only for use indoors. Do not install outdoors.
Be aware that the intended mounting surface must be free from dust and grease. Use a suitable cleaner from a specialist retailer for this.
Be aware that the adhesive pads are intended to be permanent. Carefully pull the adhesive pad off the mounting surface to remove it.
Various environmental influences, such as moisture in the air, sunlight, cold, etc., can impair the long-term stickiness of the adhesive pads.
Possible residue on the mounting surface after removal of the adhesive pads cannot be ruled out!

Installation Indoors

Warning – Installation

Before mounting, check that the wall you have chosen is suitable for the weight to be mounted. Also make sure that there are no electric, water, gas or other lines running through the wall at the mounting site.
Do not mount the product above locations where persons might sit or stand.
Buy special or suitable installation material from a specialist dealer for wall-mounting.
Never apply force during assembly.
If in doubt, have this product installed by a qualified technician – do not attempt to install it yourself.
The low weight of the product means that a screw with a plug or a nail are all that is needed to
attach it at the required installation point.
Depending on the design of the installation point (e.g. wood), you can also attach the product directly onto a screw or nail, for example, without pre-drilled holes.
Ensure before hanging the siren up that the screw or nail is securely fixed.

Commissioning

The siren can be used both in battery and mains operation.

Battery operation

Turn the cover on the back of the siren clockwise to open the battery compartment.
Remove the spent batteries and dispose of them if required. Now insert two CR123A batteries (not included). Take care to ensure the correct polarity as shown in the diagrams in the battery compartment.
Replace the cover on the back of the sensor and turn it this time anticlockwise until it locks into place.
The LED on the motion detector now flashes quickly.
If the LED does not flash quickly, remove the cover from the back and hold the pairing button for around 5 seconds.

Mains operation

Warning
When supplying power via the micro-USB port, there must no batteries in the siren.

For operation via USB, connect the supplied micro-USB cable with the micro-USB socket and a suitable USB power supply unit (not included in the scope of delivery).
Connect the power supply unit to a properly installed socket.
Only operate the product from a socket that has been approved for the device. The socket must be installed close to the product and must be easily accessible.

Integrating devices into the Hama Smart Home app

Press and hold the pairing button for around 5 seconds. The LED starts to flash red quickly. If it flashes slowly, press and hold the button again for approx. 5 seconds.
Open the app and sign in.
Press the “+ in the top right-hand corner to add a new device.
Choose Sirens from the list.
Next enter your WiFi password and confirm with “NEXT”.
Now confirm that the siren is flashing quickly by ticking “Next step” and clicking “Next”.
Your siren is now connected.
Once the connection is successful, the LED stops flashing quickly and the app confirms that your siren is connected. You can now assign it a different name if you wish.
Click Finish to end the process.
You can now attach the siren and configure it.

Note
A detailed description of the Hama Smart Home App and its full scope of functions can be found in our App Guide at:

www.hama.com Article Number < Downloads > App Operating Instructions

Setting options

The following settings can be made in the app:
Setting Option

Battery indicator
History of triggered alarms
Setting of the alarm range
more settings
Setting a timer function

For extended usage options, scenarios can be created in the app. (See Section 7 and App Guide)
Setting Timer Function

more settings:

Setting the alarm, temperature and air humidity
Selecting the alarm time and alarm tone
Selecting units and alarm volume

Alarm management options:

when the settings are activated, you will receive a push notification as information on your smartphone.

Extended usage options with scenarios

Scenarios and automated sequences that can be created in the app allow various combination options and usage options for these products, depending on the SmartHome products in your home. Programming is always via the app (see Section 4 of the App Guide) and will be offered / suggested to you on an individual basis.

Standard usage option

Extended usage option

Product characteristics
The siren can be used for monitoring (push message to the smartphone when triggered) or for controlling other smart products (e.g. lamps).

Care and maintenance

Note

Disconnect the product from the mains before cleaning and during prolonged periods of non-use

Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.
Ensure that no water is able to enter the product.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

RF exposure information

This device complies with the EU requirements for limiting the exposure of the general public to electromagnetic fields by means of health protection.
The device complies with RF specifications provided
it is used 20 cm away from the body.

Declaration of Conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00176590] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address: www.hama.com->00176590 ->Downloads.

Technical data

Power supply| 5V / 1A Alternatively via CR123A batteries (not included)
---|---
Frequency band(s)| 2.4 GHz
Maximum radiofrequency power transmitted| < 100 mW
Max. sound pressure at 1 m distance| 97.4 dB

Hama GmbH & Co KG 86652 Monheim/Germany

“Google and Google Play are trademarks of Google LLC.”
All listed brands are trademarks of the corresponding companies.
Errors and omissions excepted, and subject to technical changes.
Our general terms of delivery and payment are applied.

**Service & Support

**

** www.hama.com
+49 9091 502** Hama Logo

Documents / Resources

| hama 00176590 WiFi Smart Alarm Siren [pdf] Instruction Manual
00176590 WiFi Smart Alarm Siren, 00176590, WiFi Smart Alarm Siren, Smart Alarm Siren, Alarm Siren, Siren
---|---