hama 00176551 WiFi Touch Wall Switch Instruction Manual

00176551
WiFi Wallswitch
Operating Instructions
http://de.hama.com/qrc-smarthome-app?qr=bda

Important information – Quickreference guide:

• This quick-reference guide contains the most important basic information, such as safety instructions and the steps necessary to operate the product.
• The full text of the manual is available at the following internet address: www.hama.com ->00176551 ->Downloads
• Save the manual on your computer for reference and print it out if possible.

Explanation of warning symbols and notes

Risk of electric shock
This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.
Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

Explanation of symbols used on the product label

| The article may only be connected by a qualified electrician who complies with national regulations and those of the local energy supply company, and
who has sufficient knowledge regarding installation locations, fire protection and electrical installation work.
---|---
| The product is intended only for use inside buildings.
| Attention! There is a risk of electric shock on contact.

Package contents

• 1x WiFi wall switch
• 2x screws

Safety instructions

Warning

• The wall switch is part of the building installation. During planning and setup, the relevant national standards and directives must be observed. The device may only be operated on a 230 V 50 Hz AC voltage network. Work on the 230 V network must only be carried out by an electrician certified in your country. The applicable accident prevention regulations must be adhered to.
• To avoid an electric shock from the device, please disconnect the mains voltage (switch off the automatic circuit breaker). Failure to comply with the installation instructions can cause fires or other hazards.
• The installation must be carried out only in conventional flush-mounted sockets with a minimum depth of 40 mm.
• When connecting to the device terminals, note the permissible cables and cable cross-sections for this.
• Observe the circuit diagram carefully!
• Do not use any heat-generating devices (such as electric blankets, coffee machines, etc.) with this product. There is a risk of fire and injury.
• Do not use this product with any devices that are motorised or any devices that have a rotating component or workpiece. There is a risk of injury.
• The product is intended only for use inside buildings.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not continue to operate the device if it is visibly damaged
• Only operate with closed safety covers.
• Use the product only for the intended purpose.
• Protect the product from dirt, moisture and overheating and use it in dry rooms only.
• Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
• Only use the article under moderate climatic conditions.
• As with all electrical products, this device should be kept out of the reach of children.
• Do not operate the product outside the power limits given in the specifications.
• Do not use the product in areas in which electronic products are not permitted.
• Do not use the product in a damp environment and avoid splashing water.
• Do not drop the product and do not expose it to any major shocks.
• Do not modify the product in any way. Doing so voids the warranty.
• Dispose of packaging material immediately in accordance with the locally applicable regulations.
• The product must only be operated on a supply network as described on the type plate.
• Do not bend or crush the cable.
• Before mounting, check that the wall you have chosen is suitable for the weight to be mounted. Also make sure that there are no electric, water, gas or other lines running through the wall at the mounting site.
• Small splinters of glass can lead to injuries if touched. Dispose of the product immediately if it is damaged or splintered during application or use.
• Only touch the damaged or splintered product on undamaged areas and the edge.
• Be very careful while doing so, thoroughly wash your hands afterwards and avoid contact with face and eyes.

Here’s how easy it is:

Installation

• Switch off the relevant fuse (fuse box) for the room in which you wish to install the switch.
• Check that the wires are de-energised using a suitable measuring device (e.g. multimeter).
• Connect the WiFi touch wall switch as shown below:

• Fit the switch into a suitable wall or surface-mounted socket.
• Replace the glass cover on the switch and check that it has engaged properly.

Download the app

• Download the Hama Smart Home (Solution) APP from the Apple App Store or Google Play Store.
• Open the Hama Smart Home (Solution) APP.
• The first time you use the app, you need to register and create a new account. If you already have an account, log in with your access details.
• Follow the instructions in the app.

Note
A detailed description of the
Hama Smart Home (Solution) App
and its full scope of functions can be found in our App Guide at:

www.hama.com → Article Number → Downloads → App Operating Instructions

Getting started

• After installing the switch, the blue LED flashes quickly. If it does not flash, press and hold the button for approx. 6 seconds until the LED flashes.
• Then follow the instructions from the AppGuide.

Note

The full operating instructions can be found at www.hama.com

Care and maintenance

Note
Disconnect the product from the mains before cleaning and during prolonged periods of non-use.

• Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.
• Ensure that no water is able to enter the product.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

RF exposure information

This device complies with the EU requirements for limiting the exposure of the general public to electromagnetic fields by means of health protection.
The device complies with RF specifications provided it is used 20 cm away from the body.

Declaration of conformity

**** Hama GmbH & Co KG hereby declares that the radio equipment type [00176551] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address:
www.hama.com -> 00176551 -> Downloads.

Technical data

Hama GmbH & Co KG
86652 Monheim / Germany
Service & Support
www.hama.com
+49 9091 502-0

All listed brands are trademarks of the corresponding companies.
Errors and omissions excepted, and subject to technical changes.
Our general terms of delivery and payment are applied.
“Google and Google Play are trademarks of Google LLC.”

00176551/02.22

References

• Smart-Home-Geräte: Smarte Produkte kaufen | Hama DE
• hama.com
• hama.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>