hama 00004661 Fancy Stand 110 Selfie Stick Tripod for Mobile Phone Instruction Manual

: June 12, 2024
: Hama

Table of Contents

Fancy Stand 110 Selfie Stick Tripod for Mobile Phone
Controls and displays
Explanation of warning symbols and notes
Package contents
Safety instructions
System requirements
Commissioning
Operation
Care and maintenance
Warranty disclaimer
Technical data
Declaration of conformity
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

00004661
00004662
Selfie Stick FANCY STAND
+ Bluetooth® Remote Shutter hama 00004661 Fancy Stand 110 Selfie Stick
Tripod for Mobile Phone

Fancy Stand 110 Selfie Stick Tripod for Mobile Phone

hama 00004661 Fancy Stand 110 Selfie Stick Tripod for Mobile Phone - Figure
1

Controls and displays

LED indicator light
On/off switch
Trigger buttons
Battery compartment cover

Explanation of warning symbols and notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or important notes.

Package contents

“Fancy Stand” Selfie Stick with Bluetooth® Remote Trigger
1 CR2032 battery
These operating instructions

Safety instructions

Protect the product from dirt, moisture and overheating and use it in dry environments only.
Do not use the product in areas in which electronic products are not permitted.
Do not use the product in a damp environment and avoid splashing water.
Do not drop the product and do not expose it to any major shocks.
Dispose of packaging material immediately in accordance with the locally applicable regulations.
Do not modify the product in any way. Doing so voids the warranty.
Use the product only for the intended purpose.
This product is intended for private, non-commercial use only.
Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
As with all electrical products, this device should be kept out of the reach of children.
Do not operate the product outside the power limits given in the specifications.
Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
Do not open the device or continue to operate it if it becomes damaged.

Warning – batteries / button cells

When inserting batteries, note the correct polarity (+ and – markings) and insert the batteries accordingly. Failure to do so could result in the batteries leaking or exploding.
Only use batteries that match the specified type. Keep the instructions for the correct choice of batteries included with the operating instructions of devices safe for future reference.
Before you insert the batteries, clean the battery contacts and the polarity contacts.
Do not allow children to change batteries without supervision.
Replace all the batteries in a set at the same time.
Do not mix old and new batteries, or batteries of different types or from different manufacturers.
Remove the batteries from products that are not being used for an extended period (unless these are being kept ready for an emergency).
Do not short-circuit batteries.
Do not charge batteries.
Do not burn batteries or heat them up.
Never open, damage or swallow batteries or allow them to enter the environment. They can contain toxic, environmentally harmful heavy metals.
Remove spent batteries from the product and dispose of them without delay.

Warning – batteries / button cells

Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric pressures (such as at high altitudes).
Ensure that batteries with damaged housings do not come into contact with water.
Keep batteries out of the reach of children.
Do not swallow batteries or button cells. Burning hazard from hazardous substances.
If the battery compartment will no longer close securely, stop using the product and keep it away from children.
This product contains button cells. If the button cell is swallowed, serious internal burns can occur within 2 hours and ultimately lead to death.
If you suspect that a button cell has been swallowed or is in any part of the body, seek medical attention immediately.
Keep new and used button cells out of the reach of children.

System requirements

The Bluetooth® remote trigger supports Bluetooth® -enabled devices such as smartphones and tablet PCs running the iOS 5.0.1 or Android 4.2 operating systems or later versions.

Note

Please be aware that your device must support the Bluetooth® remote trigger if they are to be used.
Please refer to the operating instructions of your device for more information.

Commissioning

Open the battery compartment by unscrewing the screw on the battery compartment cover (4) with a screwdriver.
Remove the battery compartment cover (4) and insert a CR2032 battery, observing the correct polarity (B).
Close the battery compartment again by putting the battery compartment cover back on and tightening the screw using a screwdriver (B).

Operation

Note

The functions described in this section are only possible with Bluetooth® -enabled devices.
Note that the maximum range for Bluetooth is 10 metres without obstacles such as walls, people, etc.

6.1. BIuetooth pairing
Note – pairing

Ensure that the Bluetooth® -enabled device is switched on and that the Bluetooth® function is activated.
Make sure that your Bluetooth® -enabled device is visible for other Bluetooth® devices.
Please refer to the operating instructions of your device for more information.
Slide the On/Off switch (2) from the OFF position to ON.
The pilot light (1) starts to flash blue.
The Bluetooth® remote trigger searches for a Bluetooth® connection.
Open the Bluetooth® settings on your device and wait until the list of found Bluetooth® devices shows hama BRS4.
Select hama BRS4 and wait until the Bluetooth® remote trigger is shown as connected in the Bluetooth® settings of your device. The pilot light (1) goes out.
You can now use the Bluetooth® remote trigger.
To prolong the battery life, slide the On/Off switch (2) from ON to OFF when not using the Bluetooth® remote trigger.

6.2. Automatic Bluetooth® connection (after successful pairing)

Note

Ensure that the Bluetooth® -enabled device is switched on and that the Bluetooth® function is activated.
Make sure that your Bluetooth® -enabled device is visible for other Bluetooth® devices.
Please refer to the operating instructions of your device for more information.
The Bluetooth® remote trigger remains connected to the Bluetooth® device it was last used with.
Slide the On/Off switch (2) from the OFF position to ON. The pilot light (1) starts to flash blue.
After 3-5 seconds, the Bluetooth® remote trigger automatically pairs with the device.
You can now use the Bluetooth® remote trigger.

Note – connection impaired
After a successful initial pairing, the connection is established automatically.
If the Bluetooth® connection is not established automatically, check the following:

In your device’s Bluetooth® settings, check that hama BRS4 is connected.
If not, repeat the steps described in 6.1. Bluetooth pairing.
Check whether obstacles are impairing the range. If so, move the devices closer together.
The performance may also be impaired if the battery is low. Change the battery if necessary.
Only one Bluetooth® device can be connected at a time. If it is still actively paired to another device, disconnect this pairing and try again.

6.3. Changing the battery
The battery was designed for a use of up to 2,000 triggers, however this lifespan depends on the conditions of use. If the Bluetooth® remote trigger does not respond when the trigger button (2) is pressed, does not connect to the Bluetooth® device, etc., then change the battery as follows: See (B).

Care and maintenance

Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners. Ensure that no water is able to enter the product.

Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/ mounting, improper use of the product or from failure to observe the operating instructions and / or safety notes.

Technical data

Bluetooth® remote trigger

Bluetooth® version	5.3
Bluetooth® class	Class 2
Reach	max. 10 m
Dimensions (W x L x H)	27 x 42 x 10 mm
Weight	approx. 10 g
Battery type	CR2032

Declaration of conformity

Hama GmbH & Co KG hereby declares that the radio equipment type [00004661, 00004662] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following Internet address:

https://uk.hama.com|
---|---
https://uk.hama.com
Frequency band(s)| 2,402 GHz ~ 2,480 GHz
---|---
Maximum radio-frequency Power transmitted| 3.66 mW E.I.R.P.

Hama GmbH & Co KG
86652 Monheim / Germany
Service & Support
www.hama.com
**** +49 9091 502-0

Raccolta Carta

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Hama GmbH & Co KG is under license.
Other trademarks and trade names are those of their respective owners.

www.hama.com/nep
All listed brands are trademarks of the corresponding companies.
Errors and omissions excepted, and subject to technical changes.
Our general terms of delivery and payment are applied.
00004661_62/05.23