Pro sKit FB-1688C High Precision Fiber Cleaver Instruction Manual
- June 12, 2024
- Pro sKit
Table of Contents
FB-1688C HIGH PRECISION FIBER CLEAVER
INSTRUCTION MANUAL
FB-1688C High Precision Fiber Cleaver
Attention Please Read Me Before Operation
- Please store the product in a dry and clean place at ordinary temperature.
- Don’t wet the product, hit it violently, or wipe the rubber pad with alcohol.
- Please clean the dirt on pressure board regularly.
- Constantly clean the collector and ensure no dust and oil dirties inside.
Parameters And Structure
| Product Name | FB-1688C Fiber Cleaver | ♦ Structure |
|---|---|---|
| Applicable Bare Fiber Diameter | 125µm | 
Applicable Fiber Core| Singe Core
Fiber Cutting Length| 5-20 mm
Average Cutting Angle| <0.50
Blade Life| >48000 Times (1000 Times 16 Position 3 Adjustable Height)
Blade Type| Φ22(mm) H:2(mm)
Dimension| 91W82D51H(mm)
Weight| 235g
Fiber Fixture| 5 In 1 Fixture
Standard| Collector\Instruction Manual\Allen Key| 1. Cover Plate 2. Block 3.
Rubber Pad 4. Blade 5. Fiber Fixture 6. Base 7. Slider 8. Pressure bar 9.
Collector
Packing| PP box(110*12060mm)
Removal Method of Collector
| 
---|---
Press the cover down| Lift the collector up with a little force, then can
easily remove the collector
♦ Blade Height Adjustment Method
- Use an alien key, loosen the blade fixing screw.
- Press the blade scale with a cotton swab and turn the blade countercl ockwise to a new position.
♦ Blade Position Changing Method
- Loosen the Blade Fixing Screw with an alien key.
- Slightly adjust the Eccentric Screw, clockwise to lower blade, counterclockwise is lift blade height.
- Put the fiber which remove coating layer into fixt ure, press the cover of fixture, push the block back and forth and check if the blade touch the fiber sli ghtly. Adjust the proper position and fix the screw.
♦ Replace Blade
- Loosen Blade Fixing Screw, remove the old blade with the plastic tweezers, install a new blade.
- Adjust blade height according the method of ‘Blade Height Adjusting Method’.
Cutting Step
|
---|---
Initial state of the cleaver.| Open the cover plate and fixture cover, the
slider will automatic springback.
|
Put the fiber in.| Align the scales and make sure the fiber in horizontal
state.
|
Close the cover and push the block back to complete the cut.| Open the fixture
cover, take out the fiber.