MARATHON MAN-WSRB-3PC-01 3 Piece Rubber Strap Kit User Manual
- June 12, 2024
- MARATHON
Table of Contents
MARATHON MAN-WSRB-3PC-01 3 Piece Rubber Strap Kit
Product Information
The 3-Piece Kit includes a strap made of rubber, Swiss-made and Canadian- designed. The strap widths available are 18mm and 20mm.The rubber material used for the strap is FKM (Fluoroelastomer) which complies with the STM International Standard D1418. The kitalso includes four shoulderless spring bars and four shouldered spring bars.
SPECIFICATIONS
KIT INCLUDES
- 1x Strap, Rubber: Buckle Section (with Buckle)
- Position: 12 O’clock
- Length: 70mm
- 1x Strap, Rubber: Tail Section
- Position: 6 O’clock
- Length: 120mm
- 1x Strap, Rubber: Buckle Section
- Position: 12 O’clock
- Length: 90mm
- 4x Shoulderless Spring Bars
- 4x Shouldered Spring Bars
BUCKLE SECTION 70MM (WITH BUCKLE)
BUCKLE SECTION 90MM
TAIL SECTION
SHOULDERLESS SPRING BARS
SHOULDERED SPRING BARS
WRIST SIZE COMPATIBILITY GUIDE
To determine your wrist size, wrap a string or thread around your wrist at the point where you normally wear your watch. Mark the string where it crosses itself, lay it flat on a table and measure the distance between the marks. There are two lengths to your watch strap, the tail-end or “6 o’clock” (length of long section), and the buckle end or “12 o’clock” (length of short section, excluding buckle). NOTE: Wrist fittings are suggestions based on Marathon SAR watches, please adjust accordingly to ensure proper fit.
REMOVING THE BUCKLE
- Using a spring bar tool, insert the pin-pusher end into the drilled-through buckle hole, compressing the spring bar until it releases from the buckle. Repeat for the other side.
- Remove the spring bar completely by pulling it with your fingers. If the spring bar does not come easily, use the pin pusher end of the spring bar tool to push it out.
- Once the spring bar has been removed, the prong will slide out easily.
INSTALLING THE BUCKLE
- Insert the spring bar through one side of the strap until it reaches the cut-out.
- Insert the prong into the cut-out section and hold it in place while you push the spring bar through the rest of the way.
CAUTION: If the spring bar doesn’t go through easily, use the pin pusher
end of the
spring bar tool to push it through.
INSTALLING THE BUCKLE
- Attach one side of the buckle to the spring bar.
- Use the pin-pusher end of the spring bar tool to compress the other side of the spring bar. While holding pressure, slide the loose end of the buckle over the compressed spring bar to secure in place.
NOTE: Give the buckle a gentle pull to make sure it is attached securely.
WARRANTY & SUPPORT
Every newly purchased Marathon product comes with an International warranty
covering any manufacturing defects within the first two-years of its life. Our
expert team at service@marathonwatch.com
is dedicated to making sureyour Marathon product is running in tip-top shape.
Marathon Watch Company Ltd. warrants this item to be free from defects in
material and workmanship under normal use in accordance with care and usage
instructions for 2 years from date of purchase from an authorized distributor.
This warranty excludes damage from misuse, abuse, or any irregular
application. If we confirm a defect, we will repair or replace it with the
same item or one of similar value and return it to you at no-charge.
Marathon Watch has remained family owned and operated since our founding in
1939. This watch has been hand assembled by our team with the utmost
craftsmanship and care. Mitchell Wein, President
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>