SUSSEX Voda Wall Bath Mixer Outlet System Dress Kit Instruction Manual
- June 12, 2024
- SUSSEX
Table of Contents
Voda
Wall bath mixer outlet system Dress kit
Product code
VMOS160RH Wall bath mixer outlet system 160mm outlet
VMOS200RH Wall bath mixer outlet system 200mm outlet
VMOS250RH Wall bath mixer outlet system 250mm outlet
Mixer dress kit
– Remove Mixer protective cover.
– Using silicone, seal the wall surface around the Mixer and Outlet threads.
– Apply a small amount of silicone to the rear of the backplate prior to
mounting onto the wall.
– After Backplate has been mounted, fit the Mixer Dress Ring.
– Fit the handle body onto the Mixer Cartridge Lever ensuring the Handle is
fully engaged.
– Secure the Handle Body by tightening the Set screw using the Allen Key
provided (tighten well).
– Attach the Handle Pin.
Note: Apply a small amount of silicone or mild adhesive (Loctite) to the
thread of the Handle Pin to assist in preventing the Pin from becoming loose).
Outlet fit off
– Apply sealing tape (Teflon) to male thread.
– Place Dress Ring and Dress Flange over prepared male thread.
– Fit the Outlet.
To complete the installation, operate the Mixer(s) checking the flow of both
hot and cold water from Outlet.
Check all fittings and fixtures for water leaks.
Rough in plumbing
– Prior to installing, calculate the finished wall thickness, maximum is 30mm
thick, contact manufacturer for further options.
– If Wall thickness is greater than 30mm, contact manufacturer for further
options.
– Prepare a Nogging to be fixed parallel between the Wall Studs.
– The Nogging must be fitted to enable the base of the Masterfit to be 30-32mm
back from the Stud Face.
– The Masterfit will be marked “This side Up” to indicate orientation.
– Using the screws (x4) provided, mount the Masterfit to the Nogging. Ensure
the Masterfit is level and square.
Pipe connections
– On-site high pressure line testing must be conducted with the Mixer in the
closed position. (STATIC TEST ONLY)
– Under no circumstances is the Mixer to be opened when exceeding the maximum
stated water pressure.
– At the completion of the testing, do not relieve any high pressure by
opening the Mixer.
– Exposing the internals of the Mixer Cartridge to higher than specified water
pressures, will void the manufacturer’s warranty.
– The Hot and Cold ports are marked on the Masterfit. (Mixers have individual
Hot/Cold inlet ports).
– Flush all water feed lines. All lines must be free from any dirt and debris
before connecting to the Masterfit.
– Connect Hot and Cold lines to the corresponding 1/2” BSP ports of the
Masterfit. (see Drawing)
– Do not remove any factory fitted pressure plugs or Fixings.
Plumber note
– Once all water connections are made, check Hot/Cold water flow by operating
the Mixer Cartridge.
– Check all fittings and fixtures for leaks.
– Leave the Mixer(s) in the closed position and replace the Mixer protective
cover.
– Store the Dress Kit in a safe place until required (see Dress Finishing
Guide)
sussextaps.com.au
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS
3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is
65 deg.c
Copyright © Sussex Taps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>