FX Luminaire LE-1LED-BZ Designer Premium Down Light Instruction Manual
- June 12, 2024
- FX Luminaire
Table of Contents
FX Luminaire LE-1LED-BZ Designer Premium Down Light
Product Information
The product is a Designer/Standard Down Light available in various models: VE, LE, VL, LS. It operates at a voltage range of 11-15 V and has a power consumption of 12.5 watts. The product comes with color filters and beam angle lenses that can be changed or replaced (Designer Series only). It is equipped with a waterproof connector for secure wiring connections.
Product Usage Instructions
- To change the color filter and beam angle lens (Designer Series only), use a 5/64 Allen key to remove and replace the existing components if desired.
- Thread the cable through the fixture loop and around the desired mounting surface. Insert both ends of the cable into the lock.
- Run the wire down the structure and secure it with cable ties.
- Use a voltmeter to ensure that the voltage at the fixture is between 11 to 15 V.
- Connect the wiring using a waterproof connector.
INSTALL
- Change the color filter and beam angle lens by removing and replacing existing components if desired (Designer Series only). Use the 5/64″ Allen key.
- Thread cable through fixture loop and around desired mounting surface. Insert both cables ends into the lock.
- Run wire down the structure and secure it with cable ties.
- Use a voltmeter to ensure 11 to 15 V at the fixture.
- Connect wiring with a waterproof connector.
CIRCUITING GUIDELINES
TRANSFORMERS
-
Single transformer:
When using one transformer, center the transformer on the wattage load. Minimize all cable runs to reduce voltage drop. -
Multiple transformers:
When using multiple transformers, spread the load evenly across all transformers. Avoid voltage drop by installing the transformers as close to the fixtures as possible.
Please read and keep all safety and use instructions. If you have questions, contact your local distributor or visit the online support section at https://www.fxl.com/support.
WARNING: To reduce the risk of FIRE OR INJURY TO PERSON:
• Turn off/unplug and allow to cool before replacing lamp.
• Lamp gets HOT quickly. Contact only switch/plug when turning on.
• Do not touch hot lens, guard, or enclosure.
• Keep lamp away from materials that may burn.
• Do not touch the lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
• Do not operate the luminaire fitting with a missing or damaged shield.
WARNING : Risk of Electric Shock
• May be installed less than 5′ (1.5 m) from a pool, spa, or fountain when
used with a UL 379 listed transformer.
• A luminaire shall not use tungsten halogen lamps unless the luminaire is
marked for such lamps.
• Supply connection and electrical components are located above ground level,
except for secondary cord that is suitable for wet locations.
LOW VOLTAGE CABLE SHALL:
• Be protected by routing in close proximity to the luminaire or fitting, or
next to a building structure such as a house or deck.
• Not be buried except for a maximum 6″ (152 mm) in order to connect to the
main low voltage cable.
• Have the length cut off so that it is connected to a connector within 6″
(152 mm) from a building structure, a luminaire, or fitting.
These products contain a light source of energy efficiency class G.
LANDSCAPE & ARCHITECTURAL LIGHTING | Learn more. Visit fxl.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>