IPOTEK SK569-WU-AC Wifi Smart Power Strip Instruction Manual
- June 12, 2024
- IPOTEK
Table of Contents
IPOTEK SK569-WU-AC Wifi Smart Power Strip
Function
Product Feature
SK569-WU-AC is an American standard WiFi smart power strip ( 3 independently outlets +2 USB (Type A+C ) , which can be controlled by APP and remote. Equipped with remote control function,count down function and timer function.
Product Picture
Product Parameter
Appearance
Model#| SK569-WU-AC
Dimension
| 265*6031MM (not contains the length of power
cord, 3ft power cord)
Product color| White
Product Weight| About 490g
Parameter
Input Voltage| 125Vac/60Hz
Power Load
| 15A Max. 1875W resistive； 8A Max. 1000W
tungsten
USB| 5V, 3.4A
WiFi Parameter
| Support protocol: 802.11 b/g/n；channel: 1-14@2.4GHz ；
Support safety mode: WPA/WPA2
Standby Power Consumption| ＜0.5W
Mobile Phone System
| iOS 8.0 and above；
Android 4.4 and above
Using Instruction
- SK569-WU-AC is an American standard WiFi smart power strip ( 3 independently outlets +2 USB A+C ). The main function is to control the on/off and set timing via APP. Before using the device’s functions, you need to pairing the WiFi firstly, namely, product can connect to the Internet through WIFI, which can be a router or a mobile hotspot.
- There is a button with indicator on the housing.
- Click the button–turn on/off the power strip, the blue indicator light will light up when it is on and off when it is off;
- Long press– enter into the EZ pairing mode, the indicator will flash quickly and then connect to the network according to the EZ pairing steps.
- Long press again when the indicator flash quickly and then enter into AP pairing mode. When the indicator flash slowly, then connect to the network according to the AP pairing mode.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>