IPOTEK TX225-8-A Transmitter User Manual
- June 5, 2024
- IPOTEK
Table of Contents
IPOTEK TX225-8-A Transmitter
Function
TX225-8-A is a TOUCH series RF transmitter with 8-keys . It’s convenient to use with strip light of LST04-WR.
The product icon
Product Parameter
Outward Appearance
Product model| TX225-8-A
Product size| 3366.510.8mm
Product Color| White
Product weight| 16.9g
Product Parameter
Power Supply
| 3V（CR2032） button battery
Average standby power consumption| ****
20uA
RF RF Parameter| FSK915Mhz ， >30M remote distance
Using instruction
The instructions of RF learning configuration
TX225-8-A can match with strip light controller of LST04-WR to use.
- Connecting the strip light and controller to power on
- Press the first group of ON&OFF buttons repeatedly within 30S after the controller LST04-WR was powered on.
- If the LST04-WR can be controlled,then connect successfully.
- It can achieve remote control the switch, color selection and mode functions.
The instruction of button’s function for TX225-8-
- ON ： Turn on the strip light
- OFF ： Turn off the strip light
- UP ： When the strip light change to white light,the brightness strengthen.
- DOWN ： When the strip light change to white light,the brightness weaken.
- MODE1 ：Flashing mode
- MODE2 ： Strobe mode
- RGB ： Through RF to select the RGB.
- MODE3 ： Breathing mode
- CLEAR: Clearing the code
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving an tenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- RF warning statement:
- The device has been evaluated to meet general RF exposure requirement.
- The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>