HARVEST TEC 490 Net Wrap Light Kit John Deer Zero Series Balers Instruction Manual
- June 4, 2024
- HARVEST TEC
Table of Contents
HARVEST TEC 490 Net Wrap Light Kit John Deer Zero Series Balers
Installation Instructions
- Step 1: Locate the light kit mounting bracket (001-4883). Place the light bracket on the net wrap door support bar as shown right.
- Step 2: Mark the hole locations of the light bracket as a guide and use a 7/32” bit to drill pilot holes. Use the 1/4″-20 x 3/4″ thread cutting bolts to secure.
- Step 3: Once the bracket is attached to the support bracket (shown below) route the wiring harness along the support tube to the pivot point where it meets the cast bracket. Secure the wiring harness to the support tube with zip ties supplied in the parts bag.
Netwrap Door
Step 4: Route the wiring harness over and behind the cast bracket and cut a 3/4” hole in the net wrap cover to to thread the wire harness through (top right). Using the 3/4″ grommet cover the hole cut to ensure the harness will not be damaged any sharp plastic
Step 5: Connect the light harness (006-4883X) to caution light access on the baler, located on the front right side of the baler. The Left and right sides are determined by facing in the direction of forward travel. Utilize the 12 volt power supply for the power hookup (right circle), the left circle is MS wire.
Wiring Information
- Light / Baler
- Green or Red / White 1519
- Black / Black 050
Parts Breakdown
Harvest Tec LLC. Warranty and Liability Agreement
Harvest Tec, Inc. will repair or replace components that are found to be defective within 12 months from the date of manufacture. Under no circumstances does this warranty cover any components which in the opinion of Harvest Tec, Inc. have been subjected to negligent use, misuse, alteration, accident, or if repairs have been made with parts other than those manufactured and obtainable from Harvest Tec, Inc. Our obligation under this warranty is limited to repairing or replacing free of charge to the original purchaser any part that in our judgment shows evidence of defective or improper workmanship, provided the part is returned to Harvest Tec, Inc. within 30 days of the failure. If it is determined that a non-Harvest Tec branded hay preservative has been used inside the Harvest Tec applicator system where the failure occurred, then Harvest Tec reserves the right to deny the warranty request at their discretion. Parts must be returned through the selling dealer and distributor, and transportation charges prepaid. This warranty shall not be interpreted to render Harvest Tec, Inc. liable for injury or damages of any kind, direct, consequential, or contingent, to persons or property. Furthermore, this warranty does not extend to loss of crop, losses caused by delays or any expense prospective profits or for any other reason. Harvest Tec, Inc. shall not be liable for any recovery greater in amount than the cost or repair of defects in workmanship. There are no warranties, either expressed or implied, of merchantability or fitness for a particular purpose intended or fitness for any other reason. This warranty cannot guarantee that existing conditions beyond the control of Harvest Tec, Inc. will not affect our ability to obtain materials or manufacture necessary replacement parts. Harvest Tec, Inc. reserves the right to make design changes, improve design, or change specifications, at any time without any contingent obligation to purchasers of machines and parts previously sold. Revised 6/22
- PHONE: 715-386-9100 1-800-635-7468
- FAX: 715-381-1792
- Email: info@harvesttec.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>