DXF1645A Air Circulator Wall Mounted Fan
Instruction Manual WWW.DEWALT.com

DXF1645A Air Circulator Wall Mounted Fan

PRODUCT SPECIFICATIONS

WARNING:
As with all electrical appliances, basic safety precautions should always be followed to reduce the risk of electric shock, fire, or injury to persons, including the following precautions:
READ ALL THE INSTRUCTIONS BEFORE USING THIS FAN.
WARNING:

• Use this fan only as described in this manual. Any other use not recommended by the manufacturer may cause electric shock, fire or injury to persons.
• Do not operate the fan with a damaged power cord or after the fan malfunctions or has been dropped in any manner.
• Use of extreme caution is necessary when any fan is used by or near children, disabled persons or pets and whenever the fan is left operating unattended.
• Do not place the fan on a small, unlevel, uneven or any surface which might allow fan to tip or fall.
• For proper operation, fan should be placed on a smooth non-combustible, level surface.
• Always unplug fan when not in use, when moving from place to place, when assembling or disassembling parts, and before cleaning.
• The use of attachments that are not recommended or sold by the manufacturer may cause hazards.
• Do not use outdoors.
• Do not use fan in window. Rain may cause electrical hazard.
• Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized service facility for examination and/or repair.
• Do not run power cord under carpet. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic area where it will not be tripped over.
• Do not insert or allow any object to enter any openings on the fan. Doing so may cause electric shock and/or fire hazard. Avoid contact with moving parts.

READ &SAVE THESE INSTRUCTIONS
WARNING: Shock Hazard
Use your fan only in dry environments. This fan is not intended for use in a bathroom, laundry area, or similar locations, or near sinks, washing machines, swimming pools or other sources of water. Never locate fan where it may fall into a bathtub or other water receptacle. Do not use in damp environments such as flooded basements.
WARNING: Hot Surfaces
Do not touch fan motor when in use. This motcr is hot when in use, to avoid burns, do not let bare skin touch hot surfaces.
**WARNING: Fire Hazard
Fans have arcing or sparking parts inside. Do not use near combustible materials or flammable gases or sources of heat. DO NOT USE in areas where gasoline, paint or flammable materials are used or stored. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock, fire, or damage the fan.
WARNING: Electrical Shock Hazard
Do not use with damaged cord or plug. Use with adequate electrical system that is up to code.
WARNING: To Prevent Electric Shock
Improper connection of the equipment-grounding conductor can result in a risk of electric shock, check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance-if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
WARNING:** To Reduce The Risk Of Electric Shock
Do not use this product with any solid-state speed control device.

FAN OPERATION

WARNING: Before assembling the fan, make sure all parts are present. Compare parts with contents list. If any part is missing or damaged, do not attempt to assemble, install, or operate the product. Contact customer service for replacement parts. Unplug fan before assembling any parts to it.

1. Tools Required (Not Included):

   2 Phillips Screwdriver or Suitable Drill Equipped with

   2 Phillips Bit.

2. Fan Cradle Assembly: Simple assembly is required to use this fan as shown in Fig. A.
   1 Adjustment knob
   3 Adjustment knob pad
   5 Cradle base| 2 Foot support
   4 Drum
   6 Screw
   ---|---

• Align and insert the 1 to the side hole on 2 and 3 , tighten them with the 4. Do not over -tighten. Repeat above process for the opposite side of fan.
• Press the 5 into the back hole on 2 , then tighten the 6 on each side of the 2.

3. Fan Operation: Always operate the fan with the cradle in its upright position. The fan itself can be tilted into various positions depending on applications, including straight upward.

4. Fan Location: Place the fan in an area in the room that will provide the most effective air circulation.

5. Fan Connection: Plug fan directly into 220-240 volt A.C., 50/60Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may cause overheating and damage to the plug or fan.
   NOTE: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other electrical needs.

6. Turning Fan On: Place fan on stable level surface. Plug fan into properly grounded outlet. To start the fan, turn the switch from the OFF position to the desired fan speed.

7. Turning Fan Off: To turn the fan off, turn the switch from the current fan speed setting to the off position. Remove plug from outlet.

8. Adjusting Fan Tilt: Loosen the adjustment knob until the drum rotates freely on the frame. Adjust the fan to desired tilt angle and re-tighten the knob. Do not overtighten adjustment knob.

SUSPENDING/MOUNTING THE FAN

CAUTION: When the fan hangs by the hang hooks, do not shake the fan or the object from which it hangs. Do not hang the fan from any electrical wires or anything that is not secure. Personal injury or property damage may occur.
CAUTION: Only use the hang hooks for hanging the fan as shown in Fig. B. The hang hooks are not intended to support additional weight. Do not attach or hang anything additional to the fan or risk of breakage may occur.
CAUTION: Do not use the hang hooks to reach with or to support your weight in any situation.
CAUTION: Do not stand underneath the fan when it is mounted overhead. Serious personal injury or damage to the fan may result if the fan falls.
CAUTION: Do not mount the fan to the ceiling.
NOTE: Locate the fan away from a corner or other obstructions which may impede air flow. Your jobsite fan has multiple options for mounting.
HANG HOOK
The built-in hang hooks telescope out of the back legs and can be used to suspend the fan from 2X lumber as shown in Fig. B. Be sure to fully extend the hooks before using, then rotate as needed.

CARE and MAINTENANCE

Cleaning:
WARNING: Before cleaning the fan be sure to disconnect power cord from the plug. Clean the grill surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners.
WARNING: DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER. Replace front grill before fan use and allow fan to dry completely before use. Periodic grill cleaning with a vacuum will prevent dust build up. The motor is sealed and does not require any interior maintenance, cleaning or lubrication.
Maintenance: The Internal motor bearings are permanently lubricated at the factory and do not require any additional lubrication.
Repain
WARNING: DO NOT OPERATE THE FAN WITHOUT THE GRILL IN PLACE. DO NOT USE THE FAN IF IT HAS MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
Storage: Keep original carton for storage of the fan. Coil and tie the power cord to avoid damage during storage.

**Protecting the environment

**

**** Separate collection. Products and batteries marked with this symbol must not be disposed of with normal household waste.
Products and batteries contain materials that can be recovered or recycled reducing the demand for raw materials. Please recycle electrical products and batteries according to local provisions. Further information is available at www.2helpU.com.

OPTIONAL ACCESSORIES

WARNING: Since accessories, other than those offered by DEWALT, have not been tested with this product, use of such accessories with this appliance could be hazardous. To reduce the risk of injury, only DEWALT recommended accessories should be used with this product.

TROUBLESHOOTING

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS AND/OR ELECTRICAL SHOCK, TURN POWER SWITCH OFF AND DISCONNECT GROUNDED PLUG FROM ELECTRICAL OUTLET BEFORE PERFORMING TROUBLESHOOTING CHECKS.
Minor problems often can be fixed without calling customer service.
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

United Kingdom| DEWALT
210 Bath Road;
Slough, Berks SL1 3YD| Tel: 01753-567055
Fax: 01753-572112| www.dewaltco.uk
emeaservice@sbdinc.com
---|---|---|---
France| DEWALT
5, allee des HOtres
CS60105, 69579 Limonest Cedex| Tel: 04 72 20 39 20
Fax: 04 72 20 39 00| www.dewalt.fr
scufr@sbdinc.com

GUARANTEE

DEWALT EUROPEAN POWER TOOLS 3 YEARS GUARANTEE
DEWALT is confident of the quality of its products and offers an outstanding guarantee for professional users of the product. This guarantee statement is in addition to and in no way prejudices your contractual rights as a professional user or your statutory rights as a private non-professional user. The guarantee is valid within the territories of the Member States of the European Union and the European Free Trade Area. Subject to the DEWALT European PPT Guarantee terms and conditions available from your local DEWALT office, seller or at www.2helpU.com, if your DEWALT product becomes defective due to faulty materials or workmanship within 36 months from the date of purchase, DEWALT may replace all defective parts free of charge, or at our discretion, replace the unit free of charge. DEWALT reserves the right to refuse any claim under this guarantee which in the opinion of the authorised repair agent is not in accordance with the stated DEWALT European Guarantee terms and conditions. If you wish to make a claim, contact your seller or check the location of your nearest authorised DEWALT repair agent online, in the DEWALT catalogue or contact your DEWALT office at the address indicated in the instruction manual. A list of authorised DEWALT repair agents and full details of our after-sales service is available on the Internet at: www.2helpU.com
DEWALT EUROPEAN POWER TOOL (PT) 3 YEAR GUARANTEE The DEWALT European PT Guarantee for your product is 3 years from the date of purchase subject to the following terms and conditions.

1. General terms and Conditions
   1.1 The DEWALT European PT 3 Year Guarantee is available to the original DEWALT product user who has purchased the DEWALT products from an authorised DEWALT European reseller for use in the course of their trade or profession. The DEWALT European PT Guarantee is not available to persons purchasing DEWALT product for the purpose of resale or Hire.
   1.2 This guarantee is not transferrable. It is only available to the original DEWALT product user who has purchased the product as identified above.
   1.3 In addition to the terms and conditions outlined in this document, the terms and conditions stated in the DEWALT European PT Guarantee also apply.
   1.4 A product repair or replacement under this guarantee does not extend or renew the guarantee period. The 3 year guarantee period starts from the original purchase date and ends 36 months later.
   1.5 This product is excluded from the DEWALT 30-1-1 policy withdrawn 01-01-2016.

2. Products excluded from the DEWALT European PT 3 Year Guarantee.ln addition to the product exclusions stated in the DEWALT European PT Guarantee, section 3, the following DEWALT branded products are also excluded: Fastening Tools e.g. Nailers, Powder Impact tools. Batteries and Chargers. Rebuilt or Reconditioned products identified with additional markings – “Factory rework” and/or “0”. Compressors and generators.

3. Making a Guarantee Claim
   3.1 To make a guarantee claim contact your seller or check the location of your nearest DEWALT authorised DEWALT repair agent at www.2helpU.com.
   3.2 The DEWALT Tool must be returned to the seller or an authorised DEWALT repair agent with all parts complete, with the original proof of purchase.
   3.3 DEWALT reserves the right to refuse any claim under this guarantee which in the opinion of the authorised repair agent is not due to material or manufacturing defect or in accordance with the stated DEWALT European PT Guarantee terms and conditions.

4. Changes to Terms and Conditions
   4.1 DEWALT reserves the right to review and amend its guarantee policies, periods and product eligibility without notice as DEWALT considers appropriate.
   4.2 Current DEWALT European PT Guarantee Terms and Conditions are available from www.2helpU.com , your local DEWALT seller or DEWALT office.

EC-Declaration of Conformity

Machinery Directive
** ALTON declares that these products described under
Technical Data are in compliance with: 2006/42/EC, EN60335-1:2012 +A 11:2014 EN60335-2-69:2012.
These products also comply with Directive, 2014/30/EU and 2011/65/EU. For more information, please contact ALTON at the following address:
Alton Europe BV Logistiekweg 18 4906 AB Oosterhout The Netherlands.
E: EUSales@altonindustries.com**.

Copyright © 2023 DEWALT.
DEWALT®, the DEWALT® Logo and GUARANTEED TOUGH® are trademarks of Stanley Black & Decker Inc, or an affiliate thereof and are used under license.
Manufactured under license by Alton ltd. Group ADD:643 Innovation Drive West Chicago, IL 60185,
USA For Customer Service please visit our Online
Customer Service Centre at www.2helpU.com.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>