hp M100 Series LaserJet Printer User Guide
- June 4, 2024
- HP
Table of Contents
hp M100 Series LaserJet Printer
Control panel
Light patterns
For a complete list of light patterns, refer to user guide on: hp.com/support.
Printer features
- Output bin
- Cartridge access door
- Front door and input tray
- USB port
- Power connection
Help and tips for Wi-Fi and connectivity (wireless model only)
If the software is unable to find your printer during setup, check the
following conditions to resolve the issue.
- Potential Issue/Solution
- Printer Wi-Fi setup mode timed out/If the Wireless light is not blinking blue, the
printer might not be in Wi-Fi setup mode.
Restart setup mode:
1. Press and hold on the control panel until light starts blinking, and then release the button.
2. Wait for the printer to restart.
3. Open the HP Smart app and add the printer. If needed, swipe right/left on the top of the home screen to find the Add Printer option. Note: Only 2.4 GHz connection supported.
-
Computer or mobile device too far from printer/Move your computer or mobile device closer to the printer. Your device might be out of range of the printer’s Wi-Fi signal
-
Computer connected to a Virtual Private Network (VPN) or remote work network/Disconnect from a VPN before installing HP Smart software. You can’t install apps from the Microsoft Store when connected to a VPN. Connect to the VPN again after finishing printer setup.
Note: Consider your location and the security of the Wi-Fi network before disconnecting from a VPN. -
Wi-Fi turned off on computer (computer connected by Ethernet) If your computer is connected by Ethernet, turn on the computer’s Wi-Fi while setting up the printer. You don’t need to disconnect the Ethernet cable.
Help and Support
For printer information, troubleshooting, and videos, visit the printer support website. Enter your model name to find the printer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>