Bebe Stars 944 MJ-06 Car Seat Leon Plus i-Size Grey User Manual

: June 12, 2024
: Bebe Stars

Table of Contents

Bebe Stars 944 MJ-06 Car Seat Leon Plus i-Size Grey
Product Information
Product Usage Instructions
KNOW YOUR CHILD’S CAR SEAT
INSTALLATION GUIDE
MAINTENANCE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Bebe Stars 944 MJ-06 Car Seat Leon Plus i-Size Grey

Bebe-Stars-944-MJ-06-Car-Seat-Leon-Plus-i-Size-Grey-
PRODUCT

Product Information

This product is a child car seat designed for children with a height ranging from 100cm to 150cm. It is an i-Size child restraint approved to ECE R129/03 standards. The correct fitting of the ISOFIX anchoring systems or 3-point vehicle belts is crucial for the safety of your child. It is important to read and understand the instruction manual before using this product. Do not use unlicensed or modified products as they can be dangerous.

Product Usage Instructions

Installation Guide – 3-point Car Seatbelts (100-150cm)

Let the child sit on the child car seat.
Adjust the proper height of the headrest so that the bottom of the headrest is above the child’s shoulder.
Slide the car belt through the lap belt guides.
Slide the car belt through the belt guide.
Tighten the belt after you hear a click. Do not twist the belt.

Installation Guide – Isofix Attachments + 3-point Seat Belts

Connect the Isofix guides with the vehicle seat’s Isofix hooks.
Extend the Isofix on both sides of the child seat to the maximum length.
Push the child’s car seat to connect the Isofix with the car seat hooks. A click sound indicates that the Isofix is locked in place.
Make sure the Isofix lock indicator turns green on both sides of the child’s car seat. If the indicators are red, repeat the above process.

WARNING

Read these instructor in the manual carefully. The correct ﬁtting of the ISOFIX anchoring systems or 3-point vehicle belt is of vital importance for the safety of your child.

We advise you strongly not to use an unlicensed or modiﬁed or without the manufacturer’s instruction on the product, it is very dangerous.
This is an “i-Size” child restraint. It is approved to ECE R129/03, for general use in vehicles and it will ﬁt most, but not all car seats.
This i-Size car seat is suitable for children of heights from 100cm to 150cm.
The straps holding the restraint to the vehicle should be right, any straps restraining the child should be adjusted to the child’s body and should not be twisted.
Make sure the lap belt is stretched as low as possible over the child’s hips. DO NOT use any load-bearing force points other than those described in the instructions and marked in the child restraint.
For the future use of the seat, you must keep the instructor on the manual carefully. If in doubt, please contact the manufacturer.
NEVER leave your child una?ended in a car even for a short me.
We do not recommend installing the child safety seat in the front passenger seat.
DO NOT use a child safety seat if the vehicle seat is equipped with front airbags, it can be dangerous. This does not apply to so-called side airbags.
It is recommended that the car seat should not be used for more than 10 years from the date of production. The proper es of the products may deteriorate due to, for example, aging of the plas c which may not be visible.
DO NOT use a child safety seat that has been in a crash. A crash can cause damage to the child safety seat that you can not see.
DO NOT modify or an?empty to modify the child safety seat in any way.
DO NOT take apart or an?empty to take apart this child safety seat etc.
DO NOT use a child safety seat with damaged or missing parts.
DO NOT change the cover or harness, they are the important components.
The moving parts of the car seat should not be lubricated in any way. No altera ons should be made to the product as this could aﬀect part or the overall safety of the seat.
DO NOT remove the product’s label. There are important no ces on labels. Tell your child that he/she should never play or adjust with the seat.
We advise you strongly not to use a second-hand product because you are not sure what has happened to it.
DO NOT place the seat on the edge of the countertop or a so surface-like mattress, the seat may fall and hurt the child.
Make sure all foldable passenger seats are ﬁt in place.
Make sure there are no dangerous or corrosive substances in the car, which may damage the seat.
Make sure that all luggage and objects likely to cause injury in the event of an accident are properly secured.
The rigid items and plas c parts of a child restraint must be located and installed so that they are liable, during everyday use of the vehicle, to become trapped by a movable seat or a door of the vehicle.
Make sure the seat is in a safe position. Do not put any sharp or hard items around the seat.
Make sure that there are no other items in the clothes or pockets between the child and the seat belt, as this may cause injury in an accident.
Make sure the vehicle belt is fully secured and the car seat is correctly installed each me you use it.
Make sure that the vehicle belt is correctly fastened and does not get stuck in the car door or other sharp objects, as it may be damaged. Please replace the vehicle belt if it is damaged.
Keep the child in the car seat at all times while the car is moving.
NOTICE: The seat must be secured in the car, even when it is not in use. An unsecured seat may injure other passengers in the car in a sudden stop. Always check whether the seat parts are complete and the seat belt is fastened correctly before each use.
DO NOT use with a 2-point belt. Please install with the 3-point belt.
ONLY use for Forward Facing.

The child seat is only suitable for use if the approved vehicles are ﬁ ed with 3-point safety belts, approved to ECE R16 standards. When using the child seat on a rear seat, move the passenger seat as far forward as possible. $Bebe- Stars-944-MJ-06-Car-Seat-Leon-Plus-i-Size-Grey-FIG- $1$$

KNOW YOUR CHILD’S CAR SEAT

Shoulder seat belt guide
Fabric cover
Recline adjuster
Headrest adjuster
Adjustable headrest
Side Impact Protec on
Lap seat belt guide
Isoﬁx connector
Isoﬁx inser on guides
Shoulder pad

INSTALLATION GUIDE

Installation of 3-point car seatbelts (100-150cm)

Let the child sit on the child car seat.
Adjust the proper height of the headrest.
Ensure the bottom of the headrest is above the child’s shoulder.
Slide the car belt through the lap belt guides.
Slide the car belt through the belt guide.
Tighten the belt after you hear a click. Do not twist the belt.
Connect the Isoﬁx guides with the vehicle seat’s Isoﬁx hooks. the maximum length.
Extend the Isofix on both sides of the child seat to the maximum length.
Push the child’s car seat to connect the Isoﬁx with the car seat hooks.
A click sound indicates the Isoﬁx is locked in place.
Make sure the Isoﬁx lock indicator turns green on both sides of the child’s car seat.
If the Isoﬁx lock indicators are red, repeat the above process.
Push the baby car seat next to the backrest of the car seat tightly.
Shake the baby car seat to make sure the isoﬁx locked.
Let the baby sit on the child’s seat.
Adjust the headrest to the proper height.
Ensure the boom of the headrest is above the child’s shoulder.
Let the car belt through the lap belt guiding.
Let the car belt through the belt guide.
Tighten the belt after hearing the click, do not twist the belt.
Pull the recline adjustment handle.
Mul sea ng posi ons with one hand operation
The Side Impact Protec on (SIP) can be opened and closed by pressing on it.

MAINTENANCE

Remove the auxiliary headrest.
U n b u o n t h e c e n t r a l c o v e r underneath the headrest to remove it.
Remove the main cover by stretching the fabric inwards the seat. Reverse the process to put all fabrics back.

Hand wash only (40° warm). Use mild detergent. Do not iron, dry clean, bleach, or tumble dry. Dry ﬂat away from direct heat. DO NOT USE BLEACH, ABRASIVE, OR UPHOLSTERY CLEANING AGENTS.

Thank you for choosing Bebe Stars products

FOLLOW US

www.bebestars.gr