audio-technica 3000 Series UHF Wireless System User Guide

Quick Start Guide / UHF Wireless System

Important information

Warning:
To prevent fire or shock hazard, do not expose this apparatus to rain or moisture.

Caution:
Do not expose this apparatus to drips or splashes.
To avoid electric shock, do not open the cabinet.
Refer servicing to qualified personnel only.
Do not expose this apparatus to excessive heat such as that generatedby sunshine, fire or other heat sources.
Do not subject this apparatus to strong impact.
This apparatus should be located close enough to the AC outlet so that you can easily grasp the AC adapter at any time.
In case of emergency, disconnect the AC adapter quickly.
Battery caution:
Keep batteries out of the reach of children.
Observe correct polarity as marked.
Do not expose the battery to excessive heat such as sunshine, fire or the like.
Always consider the environment issues and follow local regulations when disposing of batteries.
Remove depleted battery immediately.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Do not place any objects filled with liquids, such as vases, on this apparatus.
To prevent fire, do not place any naked flame sources (such as lighted candles) on this apparatus.
Do not install this apparatus in a confined space such as a bookcase or similar unit.
Install this apparatus only in the places with good ventilation.
The rating label is put on the bottom of this apparatus.

Use only disposable LR06(AA) alkaline or Ni-MH batteries.
Do not use new batteries and old one at the same time.
Do not use different batteries type or model.
Do not use a leaking battery. If battery leakage occurs, avoid contact with skin.
If contact occurs, immediately wash thoroughly with soap and water.
If battery leakage comes into contact with your eyes, immediately flush with water and seek medical.

For customers in the USA

FCC Notice
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference  that may cause undesired operation.
Caution:
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential  installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,  the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Contact:
Responsible Company: Audio-Technica U.S., Inc.
Address: 1221 Commerce Drive, Stow, Ohio 44224, USA
Tel: 330-686-2600

For customers in Canada
IC statement
CAN RSS-Gen/CNR-Gen
This device complies with INDUSTRY CANADA R.S.S. 210. Operation is subject to the following conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference which may cause undesired operation.
This device complies with RSS-102 radiation exposure limits set forth for an uncontrolled environment.

About User Manual

For details, refer to the user manual available for download on our website: www.audio-technica.com

http://www.audio-technica.com

Part names and functions

ATW-R3210

❶ Power button
❷ IR sync window
❸ Display
❹ BACK button
❺ Control dial

❶ Antenna input jack
❷ Unbalanced output jack
❸ Balanced output jack
❹ Ground lift switch
❺ Power input jack

ATW-T3201 / ATW-T3201a

❶ Transmission antenna
❷ MUTE switch
❸ Indicator
❹ Function button
❺ Input connector
❻ Display
❼ SYNC button
❽ UP button
❾ BACK button
❿ Power switch
⓫ SET button
⓬ DOWN button
⓭ Battery cover
⓮ IR sync window
⓯ Charging terminals

ATW-T3202 /ATW-T3202a

❶ Interchangeable capsule
❷ Display
❸ Grip case
❹ UP button
❺ BACK button
❻ IR sync window
❼ DOWN button
❽ SET button
❾ SYNC button
❿ Power switch
⓫ Battery cover
⓬ Function button
⓭ Indicator
⓮ Charging terminals

Inserting batteries

Making connections

Turning the power on

About IR QUICK SYNC

You can easily send the frequency and the channel name of the receiver with QUICK SYNC. Refer to the user manual for full details on how to set frequency and channel name.

Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan
www.audio-technica.com
©2022 Audio-Technica Corporation
Global Support Contact: www.at-globalsupport.com

References

• 中央テクニカ株式会社 – 栃木県真岡市でビル管理やビル清掃、モップやマットのレンタル事業を行っています。
• Global Support｜Audio-Technica Corporation オーディオテクニカ
• オーディオテクニカ
• サポート総合（個人向け製品）｜株式会社オーディオテクニカ
• Audio-Technica Corporation | Headphones, Microphones & Turntables | Audio-Technica

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>