Bebe Stars LYB959 Car Seat User Manual
- June 12, 2024
- Bebe Stars
Table of Contents
LYB959 Car Seat
User Manual
Your child’s safety depends on you. Proper product’s use cannot be assured
unless you follow these instructions.
DO NOT USE THIS PRODUCT BEFORE YOU READ AND UNDERSTAND THESE INSTRUCTIONS
SAFETY NOTES
WARNING
Read this instruction manual carefully.
The correct fitting of the ISOFIT anchoring systems or 3-point vehicle belt is
of vitalimportance for the safety of your child.
We advise you strongly not to use an unlicensed or modified or without
manufacturer’sinstruction product, itis very dangerous.
This is a “Universal” “Specific Vehicle” child restraint. It can be installed
by Vehicle Seat belt separately or by Vehicle Seat belt+ISOFIT. It is for
general use invehiclesand it will fitmost, but not all car seats.
The straps holding the restraint to the vehicle should be tight, any straps
restraining the child should be adjusted to the child’s body and should not be
twisted.
Make sure the lap beltis stretched as low as possible over the child’s hips.
DO NOT use any load bearing force points other than those described in the
instructions and marked in the child restraint.
For the future use of the seat, it is important that you keep the instruction
manual carefully. Ifin doubt,please contact the manufacturer.
This is a “Universal” child restraint. It is approved to ECE R44/04, for
general useinvehicles and it will fit most, but not all car seats.
NEVER leave your child unattended in a car even forashorttime.
We do not recommend installing the child safety seat in the front passenger
seat.
DO NOT use a child safety seat if the vehicle seat is equipped with front
airbags, it can be dangerous. This does not apply to so-called side airbags.
It is recommended that the car seat should not be used more than 5 years from
the date of production. The properties of the products may deteriorate dueto,
for example, ageing of the plastic wich may not be visible.
DO NOT use a child safety seat that has been in a crash. A crash can cause
damage to the child safety seat that you can not see.
DO NOT modify or attempt to modify the child safety seatin any way.
DO NOT take apart or attempt to take apart this child safety seat etc.
DO NOT use a child safety seat with damaged or missing parts.
DO NOT change the cover or harness, they are the important components.
The moving parts of the car seat should not be lubricated in any way.
No alterations should be made to the product as this could affect part or the
overall safety of the seat.
DO NOT remove the product’s label. There are important notices on labels.
Tellyour child that he/she should never play or adjust with the seat.
We advise you strongly not to use a second-hand product, because you are not
sure what has happened toit.
DO NOT place the seat on the edge of countertop or a soft surface like
mattress, the seat may falland hurt the child.
Make sure all foldable passenger seats arefitin place.
Make sure there are no dangerous or corrosive substances in the car, which may
damage the seat.
Make sure that all luggage and objects likely to cause injury in the event of
an accidentare properly secured.
The rigid items and plastic parts of a child restraint must be located and
installed so that they are liable, during everyday use of the vehicle, to
become trapped by amovable seat ora door of the vehicle.
Make sure the seat is in a safe position. Do not put any sharp or hard items
around the seat.
Make sure that there are no other itemsin the clothes or pockets between the
child and the seat belt, as this may cause injury inanaccident.
Make sure the vehicle belt is tightly secured and the car seat is correctly
installed each time you use it.
Make sure that the vehicle belt is correctly fastened and does not get stuck
in the car door or other sharp objects, as it may be damaged. Please replace
the vehicle beltifitis damaged.
Keep the childin the car seat at all times while the car is moving.
NOTICE: The seat must be secured in the car, even when it is not on use. An
unsecured seat may injure other passengers in the carinan sudden stop.
Always check whether the seat parts are complete and the seat belt is fastened
correctly before each use.
DO NOT use with 2-point belt. Please install with the 3-point belt.
ONLY use for Forward Facing.
NOTICE!
This is a “Universal” child restraint. It is approved to Regulation No.44/04
series of amendments, for general use in vehicles and it will fit most, but
not allcarseats.
A correct fit is likely if the vehicle manufacturer has declared in the
vehicle handbook that the vehicle is capable of accepting a”Universal” child
restraint for this age group.
Ifin doubt, contact either the child restraint manufacturer or the retailer.
This is a “ISOFIT” child restraint. It is approved to Regulation No.44/04
series of amendments, for general use in vehicles fitted with ISOFIX
anchorages systems.
It will fit vehicles with positions approved as ISOFIX positions (as detailed
in the vehicle handbook), depending on the category of the child seat and of
the fixture.
Only use with 3-point belt.
Do not use on front passenger seats with a frontairbag!
Checkif the safety seatisinstalled correctly.
Correctinstallation s crucialy important for child safety.
The seat must be installed according to the labels or instructions.
Notice! Do notadd any parts between the safety seat and the vehicle seat.
BOOSTER PARTS
- Shoulder belt strap
- Backrest
- Base
- Waist guide
- ISOFIX attachment
- Cup holder
- Backrest connector
- Adjust lock button
- Red belt guide
INSTALLATION GUIDE
Installation with seat belt + ISOFIX combination
- Find the ISOFIX anchorages on vehicle seat, install the two ISOFIX guides.
- Press the ISOFIT release button and push the connectors forward.
- Push the ISOFIT Interface into the ISOFIX anchorages until you heara “click “.
Agreen mark will turn up on the button (if red, please repeat the above steps.
Seat belt setup
- Place your child on the seat, adjust the shoulder belt strap to a suitable length.
- Pull the seat belt, put it through red belt guide at the top of seat back and pass it through the waist guide, fasten it until you hear a “click”.
- Tighten the seat belt, adjust the suitable belt tightness according to the child. Stretch the belt aslow as possible, so the child’s hips can be good fixed.
Installation with vehicle seat belt
- Make sure the ISOFIT connectors are turn back to the seat, put the seat to the back passenger seats.
- Place your child on the seat, adjust the shoulder strap toasuitable length.
- Pull the seat belt, put it through red belt guide at the top of seat back and pass it through the waist guide, fasten it with an audible sound“click”.
- Tighten the seat belt, adjust the suitable belt tightness according to the child. Make sure the lap belt is stretched as low as possible, so the child’s hips can be good fixed.
Removal of the car seat
- Press the two ISOFIT release buttons, a red mark will turn up.
- Pull out the seat until it is removed.
CARE & MAINTENANCE
- The cover can be removed and washed with mild soapy water gently. Do not use any detergent, solvent or strong soap.
- Do not spin, and never tumble dry in a dryer machine (the fabric may separate from the padding).
- The plastic parts can be cleaned using soapy water. Do not use harsh cleaning agents (such as solvents).
Clean with amild detergent under 30°C, then gently rub with your hand.
Thank you for choosing Bebe Stars products
FOLLOW US
www.bebestars.gr https://www.bebestars.gr/?s=915-
bebestarsbygilis
@bebe.stars
bebestarsbygilis
63200 | Nea Moudania | Greece
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>