EPH Controls CM2 Room Thermostat Hardwired Instruction Manual
- June 12, 2024
- EPH CONTROLS
Table of Contents
EPH Controls CM2 Room Thermostat Hardwired
Product Information
Product Name: CM_ Room Thermostat Hardwired
Type: 1C
Standards: EN60730, EN60529
IP Rating: IP20
Operating Range: 5-95%RH
Manufacturer: EPH Controls
Contact Information:
- Ireland: technical@ephcontrols.com, www.ephcontrols.com
- UK: technical@ephcontrols.com, www.ephcontrols.co.uk
Product Usage Instructions
- Ensure that the thermostat is installed and connected by a qualified person in accordance with national wiring regulations.
- Prior to commencing any work on the electrical connections, disconnect the thermostat from the mains.
- Do not leave the thermostat unsupervised when it is open. Prevent non-specialists, especially children, from gaining access to it.
- Using the thermostat in a way not specified by the manufacturer may impair its safety.
- Complete all required settings described in the user manual before setting the thermostat.
- The thermostat can be mounted in the following ways:
- To a recessed conduit box
- To a surface mounted box
- Directly mounted on the wall
Installation Instructions
For use in normal environments.
The above image displayed is product CM2, design of other products in the CM_
range may vary.
Important : Keep this document
CAUTION! Installation and connection should only be carried out by a qualified person and in accordance with national wiring regulations.
- Before commencing any work on the electrical connections, you must first disconnect the thermostat from the mains.
- None of the 230V connections must be live until the installation has been completed and the housing is closed.
- Only qualified electricians or authorised service staff are permitted to open the thermostat.
- There are parts that carry mains voltage behind the cover. The thermostat must not be left unsupervised when open. (Prevent non specialists and especially children from gaining access to it.)
- I f the thermostat is used in a way not specified by the manufacturer, its safety may be impaired.
- Prior to setting the thermostat, it is neccessary to complete all required settings described in this section.
This thermostat can be mounted in the following ways:
- To a recessed conduit box
- To a surface mounted box
- Directly mounted on wall
EPH Controls Ireland
technical@ephcontrols.com
www.ephcontrols.com
EPH Controls UK
technical@ephcontrols.com
www.ephcontrols.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>