SUSSEX RBS150 Wall Bath Set Instruction Manual
- June 12, 2024
- SUSSEX
Table of Contents
SUSSEX RBS150 Wall Bath Set
Product Information
- Product Name: Circa Wall Bath Set
- Components:
- Set Screw
- Handle Body
- Locking Sleeve
- Fibre Washer
- Ceramic Spindle Cartridge
- O Ring
- Outlet Flange
- Basin Body Locknut
- Locking Screw
- Plastic Washer
- Outlet Locknut
- Breech
- Product Codes:
- RBS150 – Wall bath set 150mm
- RBS200 – Wall bath set 200mm
- RBS250 – Wall bath set 250mm
- RBS150-V – Wall bath set 150mm – Vertex
- RBS200-V – Wall bath set 200mm – Vertex
- RBS250-V – Wall bath set 250mm – Vertex
- Maximum Thickness: 28 mm
- O Ring Size: 60 mm Spindle 32 – 35 mm
- Outlet Flange Label: Front
- Installation Guidelines:
- The tee piece is to be breached between basin bodies. The length of the Tee piece may require cutting to suit.
- The locking Sleeve must be fully tightened to the Basin Body prior to tightening the assembly from underneath.
- Tighten Basin Body Locknut only after the Locking Sleeves have been fully tightened.
Product Usage Instructions
- Mounting Surface:
- The Fibre washer must seal the Locking Flange to the Basin Body.
- Use locking screws to secure the assembly from under the bench.
- Raise the Basin Body assembly through the Mounting Surface to tighten the Locking Sleeve.
- Tapware Installation:
- Tapware should be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003.
- Recommended working water pressure: 300-500 kph.
- Maximum water temperature: 65 deg. c.
For more information, visit sussextaps.com.au AS/NZS 3718:2005 LIC. 20081
Product code
- RBS150 Wall bath set 150mm
- RBS200 Wall bath set 200mm
- RBS250 Wall bath set 250mm
- RBS150-V Wall bath set 150mm – Vertex
- RBS200-V Wall bath set 200mm – Vertex
- RBS250-V Wall bath set 250mm – Vertex
Installation guidelines
- The Spindles will be supplied fitted into the Basin Bodies when supplied.
- Determine the distance of the Basin/Hob holes and cut the breech to suit.
- Place the Outlet Locknut and Plastic Washer over the outlet fitting of the Breech.
- Align the breeched Basin Bodies and fit through the mounting surface.
- Fit the Fibre Washer over the spindles.
- Raise the assembled Basin Body through the mounted surface and fit the Locking Sleeves.
- Fully tighten the Locking Sleeves and ensure O Ring is intact before lowering the assembly onto the mounting surface. (See Fig.1)
- Working from underneath tighten the Basin Body Locknut to secure the assembly.
- The outlet must be secured with the FRONT label facing the user.
- Remove the label after the final installation.
- Fit the Outlet to the Breech and secure by tightening the locknut, ensure O Ring is intact.
- Once all parts are tightened fit the Handle and secure it with Set Screw using Allen Key.
- Connect Hot and Cold feed lines to the Basin Bodies.
- Check all parts, fittings, and connections for any water leaks.
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
- Recommended working water pressure 300-500 kph. Maximum water temperature is 65 deg.c Copyright © Sussex Taps.
- sussextaps.com.au.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>