SUSSEX Circa Basin Set Instruction Manual
- June 12, 2024
- SUSSEX
Table of Contents
Basin set
Product code
| RBS | Basin set |
|---|---|
| RBSHS | Basin sink set high |
| RBS-V | Basin set – Vertex |
| RBSHS-V | Basin sink set high – Vertex |
Installation guidelines
- The Spindles will be supplied fitted into the Basin Bodies when supplied.
- Determine the distance of the Basin/Hob holes and cut the breech to suit.
- Place the Outlet Locknut and Plastic Washer over the outlet fitting of the Breech.
- Align the breeched Basin Bodies and fit through the mounting surface.
- Fit the Fibre Washer over the spindles.
- Raise the assembled Basin Body through the mounted surface and fit the Locking Sleeves.
- Fully tighten Locking Sleeves and ensure O Ring is intact before lowering assembly onto mounting surface. (See Fig.1)
- Working from underneath tighten the Basin Body Locknut to secure the assembly.
- Outlet must be secured with the FRONT label facing the user.
- Remove label after final installation.
- Fit the Outlet to Breech and secure by tightening the locknut, ensure O Ring is intact.
- Once all parts are tightened fit Handle and secure with Set Screw using Allen Key.
- Connect Hot and Cold feed lines to the Basin Bodies.
- Check all parts, fittings and connections for any water leaks.
AS/NZS 3718:2005
LIC. 20081 WATER RATING
www.waterrating.gov.au
5.0 litres per minute
In accordance with AS/NZS 6400
Licence No. 0124
Sussex Taps Pty Ltd
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS
3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is
65 deg.c Copyright © Sussex Taps.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>