VISUAL COMFORT BBL 3601 Chado Large Table Lamp Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT BBL 3601 Chado Large Table Lamp
Product Information
- Product: Chado Large Table Lamp
- Item Number: BBL 3601
Notice:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
- Tools Required (Not Included): Scissors
- Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Product Usage Instructions
- Carefully remove all parts from the box. Place on a clean, soft surface.
- Remove socket ring (D) from socket cup (G).
- Install saddle (F) to socket cup (G) and secure with socket ring (D).
- Install harp (C) onto saddle (F), adjust harp (C) to desired height, then tighten adjustment knobs (E).
- Remove finial (A) from harp (C).
- Remove shade (B) from packaging and install to harp (C) using finial (A). Note: If shade has additional packaging, carefully cut off from interior of shade to avoid damages.
- Install light bulb into the socket.
- Remove protective cover (H) from plug.
- Plug into electrical outlet and test the fixture.
Chado Large Table Lamp
- Item # BBL 3601
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
- Scissors
ASSEMBLY INSTRUCTIONS
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove socket ring (D) from socket cup (G).
-
Install saddle (F) to socket cup (G) and secure with socket ring (D).
-
Install harp (C) onto saddle (F), adjust harp (C) to desired height, then tighten adjustment knobs (E).
-
Remove finial (A) from harp (C).
-
Remove shade (B) from packaging and install to harp (C) using finial (A).
NOTE: If shade has additional packaging, carefully cut off from interior of shade to avoid damages. -
Install light bulb into the socket.
-
Remove protective cover (H) from plug.
-
Plug into electrical outlet and test the fixture.
Care Instructions
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.