VISUAL COMFORT SP 2022 Hackney Single Sconce Wall Light Instruction Manual

VISUAL COMFORT SP 2022 Hackney Single Sconce Wall Light

Product Information

Product Name: Hackney Single Sconce

Item Number: SP 2022

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar withthe construction and operation of it, as well as the hazards involved. Inspect the item and its contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

Tools Required

(Not Included)

• Phillips Screwdriver
• Slotted Screwdriver

Product Usage Instructions

1. Carefully remove all parts from the box and place them on a clean, soft surface.
2. Remove the mounting plate (G) from the fixture (E) by unscrewing the screws (H).
3. Install the mounting plate (G) to the junction box and secure it with the provided mounting screws (F).
4. Wrap the fixture ground wire (bare copper) around the green grounding terminal in the junction box and tighten it securely.
5. Connect the fixture wires to the corresponding wires in the junction box: black to black (hot), white to white (neutral), and green or bare copper to the grounding wire.
6. Tuck the connected wires carefully into the junction box and attach the fixture to the mounting plate using the screws (H).
7. If applicable, insert the recommended bulb into the fixture. Please note that the bulb is not included with the product.
8. After installation, carefully clean the fixture using only a soft dry cloth or feather duster. Do not use abrasive or chemical agents.

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver

ASSEMBLY INSTRUCTIONS

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (G) from fixture (E) by removing screws (H).

3. Install mounting plate (G) to the junction box and secure with the mounting screws (F).

4. Wrap fixture ground wire (bare copper) around the green groundingscre . Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (D).
   NOTE: It is imperative that the fixture is grounded.

5. Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (D).

6. Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (D).
   CAUTION: Do not reverse the hot and neutral connections.

7. Make sure all wire connections are tight, then carefully tuck into the junction box.

8. Install fixture (E) to mounting plate (G) by securing with screws (H).

9. Install shade (B) on the socket (C) and secure with socket ring (A).

10. Install light bulb into socket (C).

Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>