DEWALT Pure110+ and AC200+ Adhesive Anchoring System Instruction Manual
- June 12, 2024
- Dewalt
Table of Contents
Pure110+ and AC200+ Adhesive Anchoring System
Instruction Manual
Pure110+ and AC200+ Adhesive Anchoring System
Supplemental Installation Instructions for Preparation of the Adhesive in
Step #3: Cartridge Balancing
Cartridge adhesives must be properly mixed to achieve published properties for
anchoring applications into concrete and masonry.
In accordance with the Manufacturer’s Printed Installation Instructions (MPII)
the supplied mixing nozzle must be attached to the cartridge. The cartridge is
loaded into the recommended dispensing tool. Prior to dispensing adhesive into
the drilled hole, separately dispense at least three full strokes of adhesive
through the mixing nozzle until the adhesive is a consistent color: product
must be Red color for mixed Pure110+ product or Gray color for mixed AC200+
product.
During consecutive installations using DEWALT piston plugs, it is permissible
to transfer the piston plug assembly (nozzle, flexible tubing extension and
piston plug) to a new cartridge when the initial cartridge is depleted. For
the transfer and continued use of
the piston plug assembly to be viable, the cartridge balancing steps shown
below and restart of dispensing adhesive into the hole must be completed
within the published working time of the adhesive as provided in the MPII.
Procedure for Cartridge Balancing:
- Remove piston plug assembly from the depleted cartridge.
- Load a new cartridge into dispensing tool (without new mixing nozzle).
- Remove cap and balance cartridge by dispensing adhesive until both components are flowing separately and equally through the cartridge opening. Suggest removing any excess adhesive from cartridge opening prior to the next step.
- Attach nozzle of piston plug assembly to the balanced cartridge.
- Resume dispensing and placement of adhesive into hole.
Provided these steps are followed, replacing the piston plug assembly with each new cartridge is not necessary. This supplemental procedure for cartridge balancing has been tested and determined to be equivalent to the standard procedures given in the MPII.
DEWALT
701 East Joppa Road
Towson, MD 21286
P: 800-524-3244
anchors.DEWALT.com
Technical Bulletin
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>