Cobra CWA BT300 Air Wave Mini Speaker User Guide
- June 3, 2024
- Cobra
Table of Contents
Cobra CWA BT300 Air Wave Mini Speaker
IMPORTANT
To get the full capability of your new Cobra Airwave Mini, please read this
manual. It’s more than just a Bluetooth Speaker!
CARE AND MAINTENANCE
- Never try to disassemble or service the product by yourself.
- Keep the Cobra Airwave” Mini and accessories out of reach from children.
- Do not expose the Cobra Airwave Mini to temperatures above +55 deg C(+131 deg F). If the product is operated in extreme hot or cold temperature, the battery capacity is reduced. Use it at room temperature for maximum battery capacity.
CHARGING
The Cobra Airwave Mini has a built-in Li-ion battery (3.7V, 1600 mAH), so it can be used without connecting to a power supply. To charge the battery, follow these steps:
- Connect the micro USB connector to the Cobra Airwave Mini micro-USB input.
- Plug the USB full-size connector into the micro- USB input. A common USB-type AC charger (DC 5V, 500mA) or any USB power source.
- When the device is charging the LED status indicator will be RED. When fully charged the RED status indicator LED will go off.
- A full charge will last for up to 12 hours of normal use.
OPERATION
Turning the Cobra Airwave® Mini On or Of
- Press and hold the Multi-Button for 3 seconds to turn On.
- The blue LED will turn on and blink. Press and hold the Multi-Button for 5 seconds to turn Off. The red LED will turn on then turn off.
Pairing the Cobra Airwave® Mini with a smartphone or any Bluetooth® enabled music device
To use the Cobra Airwave® Mini with any Bluetooth® enabled smartphone or media device, you must first pair the device to the Cobra Airwave® Mini. Once they have been paired for the first time, the phone or media device will automatically re-connect to the Cobra Airwave® Mini when the power is turned ON and Bluetooth® is enabled on your device. For additional information, see the operation manual for your smartphone or media device.
Connecting with smartphone
- Turn Bluetooth® on in your settings menu. It will begin searching for any Bluetooth® device within range.
- With power off, press and hold the Multi-Button for 7 seconds until a double-beep sound and the blue and red LEDs will alternately blink.
- You will see the Cobra Airwave® Mini on the devices list on your phone. Select the Cobra Airwave Mini to pair. A single beep will sound and “Connected” will appear in the device’s screen. Once connected, the blue LED light will blink on the device.
ADJUSTING VOLUME
To adjust the Cobra Airwave® Mini volume, press on the “+” or “–” buttons to increase or decrease volume.
- Volume can be adjusted with Cobra Airwave® Mini controls or the paired Bluetooth® device connected to the Cobra AirWave® Mini
Pairing a new device with the Cobra Airwave® Mini
- Use the smartphone or paired devices’ BT settings to unpair the BT 300 Mini.
- Turn on BT/scan with a different device.
- Connect with new device and play.
Answer/hang up/place a call
If a call comes through in Stand By mode or while playing music, click on
Multi-Button to answer the call. To hang up, press the Multi-Button again.
FCC & INDUSTRY CANADA STATEMENT
For Products Purchased in the USA:
NOTE: This device complies with part 15 of FCC rules: Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received including interference that may cause undesired operation.
CAUTION: Modifications or parts not approved by Cobra Electronics Corporation may violate FCC Rules and void authority to operate this equipment.
For Products Purchased in Canada:
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device complies with Part 15 of the FCC Rules
and with RSS-210 of Industry Canada. Operation is subject to the following two
conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
This Class B digital apparatus complies with Canadian ICES-003.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications or changes to this
equipment. Such modifications or changes could void the user’s authority to
operate the equipment.
This equipment is portable device. The output power of this device is less
than 20mW.The SAR test is not required.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Trademark Statement
Airwave®, Cobra® and the snake design are registered trademarks of Cobra
Electronics Corporation, USA. Cobra Electronics Corporation™ is a trademark of
Cobra Electronics Corporation, USA. iPhone®, iPod® touch and Siri® are
trademarks of Apple, Inc, registered with the U.S. and other countries.
Samsung S Voice® is a registered trademark of Samsung Electronics Company,
LTD.
The Bluetooth® word mark is a registered trademark owned by Bluetooth SIG,
Inc. and any use of such marks by Cobra Electronics Corporation is under
license.
PRODUCT SERVICE QUESTIONS
For any questions about operating or installing this new Cobra product, or if
parts are missing…PLEASE CALL COBRA FIRST… do not return this product to the
store.
For Products Purchased in the U.S.A. If your product should require factory
service, please call Cobra first before sending your radio. This will ensure
the fastest turn-around time on your repair. You may be asked to send your
radio to the Cobra factory. It will be necessary to furnish the following to
have the product serviced and returned.
-
For warranty repair include a copy of the original sales receipt. If you send the original receipt, it cannot be returned.
-
Send the entire product.
-
Enclose a detailed description of the problem along with the name and address of where the product is to be returned.
-
Pack radio securely to prevent damage in transit. If possible, use the original packing material.
-
Ship prepaid and insured by way of a traceable carrier such as United Parcel Service (UPS) or Priority Mail to avoid loss in transit to Cobra Factory Service:
Cobra Electronics Corporation 6500 West Cortland Street Chicago, Illinois 60707 U.S.A. -
If the radio is under warranty, it will be repaired or exchanged depending on the model.
Please allow approximately three to four weeks before contacting Cora for status. If the product is out of warranty, a letter will automatically be sent informing you of the repair charge or replacement charge. If you have any questions, please call 800-262-7212 for assistance.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for product service information.
LIMITED ONE-YEAR WARRANTY
For Products Purchased in the U.S.A.
Cobra Electronics Corporation warrants that its products and the component
parts thereof will be free of defects in workmanship and
materials for a period of one year from the date of first consumer purchase.
This warranty may be enforced by the first consumer purchaser, provided that
the product is utilized within the U.S.A.
Cobra will, without charge, repair or replace, at its option, defective
products, products or component parts upon delivery to the Cobra Factory
Service department, accompanied by proof of the date of first consumer
purchase, such as a duplicated copy of a sales receipt. You must pay any
initial shipping charges required to ship the product for warranty service,
but the return charges will be at Cobra’s expense if the product is repaired
or replaced under warranty. This warranty gives you specific legal rights, and
you may also have other rights which may vary from state to state.
Exclusions: This limited warranty does not apply: 1) To any product damaged by
accident; 2) In the event of misuse or abuse of the product or as a result of
unauthorized alterations or repairs; 3) If the serial number has been altered,
defaced, or removed; 4) If the owner of the product resides outside the U.S.A.
All implied warranties, including warranties of merchantability and fitness
for a particular purpose are limited in duration to the length of this
warranty. Cobra shall not be liable for any incidental, consequential or other
damages; including, without limitation, damages resulting from loss of use or
cost of installation.
Some states do not allow limitations on how long an implied warranty lasts
and/or do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitations may not apply to you.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for warranty information.
Quick Reference Guide
©2014 Cobra Electronics Corporation 6500 West Cortland Street, Chicago, IL
60707
www.cobra.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>