WELLFOR WA6001MB WA Bathroom Shower Set Instruction Manual
- June 12, 2024
- WELLFOR
Table of Contents
- New installations
- Installation Preparation
- Accessory list
- Dimentional drawing
- Chiseling wall diagram
- Pipe-connection diagram
- Water test and leak detection
- Wall tiling program
- Cover and handle installation
- Shower sets installation
- Handle shower installation
- Cleaning & Maintenance
- Important notice
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
INSTALLATION MANUAL
Concealed installation shower set
New installations
NOTE!!!
- Supply lines should be purged to clean impurities before connecting the unit.
- The hot water supply should be connected to the left and the cold water supply to the right, when viewed from the operating position. If this is not taken into account can cause permanent damage to the cartridge.
- Screw connections and test for leaks.
- Using a spirit level on the cams, the mixer align horizontally,vertically and parallel to the wall.
- Warm reminder:
In the cold areas or the indoor temperature is less than 4 ℃ in Winter, if no using the faucets for a long time, please turn off the inlet water valve and drain the remaining water inside the supply pipe, which can avoid the faucet damage caused by the expansion of the frozen water.
Installation Preparation
- Read the instructions carefully before installing.
- The installation must be performed by a qualified person.
- Installation tools:
Accessory list
| No. | Description | Qty. |
|---|---|---|
| 1 | Concealed installation valve | 1 |
| 2 | Cover board | 1 |
| 3 | Diverter handle | 1 |
| 4 | Cartridge handle | 1 |
| 5 | Elbow with hook | 1 |
| 6 | Shower hose | 1 |
| 7 | Handle shower | 1 |
| 8 | Shower head | 1 |
| 9 | Shower arm | 1 |
| 10 | Cover board | 1 |
| 11 | Allen-key | 1 |
| 12 | Nails bag | 1 |
Dimentional drawing
Chiseling wall diagram
Pipe-connection diagram
Water test and leak detection
- After connecting all pipes, please dis-assembling the plastic protection cover , and switch on/off the cartridge , check all connections without any leakage, and all connections connecting to the required functional outlets.
- Re-install the plastic protection cover to the valve.
Wall tiling program
- Use a parallel ruler to make sure the wall and valve being parallel.
- Use a knife to cut the rest of plastic edge above the tiles.
Cover and handle installation
- Take off the plastic protection cover.
- Put the cover board on the valve and tight the handle firmly.
Shower sets installation
Handle shower installation
Cleaning & Maintenance
To keep the product clean& shining, follow the steps as follows:
- Flush with clean water & dry with soft cloth only;
- If any dirt, clean with soft liquid or transparent glass detergent.
- Do not use any scrubbing detergent, polisher, sand -cloth, paper tissue or scraper.
- Do not use acid detergent, insoluble & grain-like detergent or soap.
Important notice
- Users under age 14 must be accompanied by an adult otherwise young users may be scalded by hot water.
- All users need to be careful when you turn cold water to hot water.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>