WELLFOR HW-HGY-66423 2-Seat Black Metal Outdoor Bench Instruction Manual
- October 30, 2023
- WELLFOR
Table of Contents
Instruction Manual
Before You Start
Read each step carefully before starting. It is very important to ensure each
step followed in correct order, otherwise assembly difficulties may occur.
Most of board parts are labeled or stamped on the raw edges. Have a check to
make sure all parts are included.
Work in a spacious area, preferably on a carpet close to where the unit will
be used.
Keep the handtools close at hand. Do not use power tools to assemble your
furniture. They may scratch or damage the parts.
Board Identification
Not actual size
Arms x 2
Back x 1
Seat x 1
Hardware List
Actual size
BOLT
STEP 1
Attach the seat slat C to the arm B by bolts D with washers F. nuts G through
the pre-drilled holes on the arm and the pre-drilled holes on the seat. Repeat
step for the other side arm B.
IMPORTANT: Do not tighten completely until assembly is completed.
STEP 2
Attach the back A to the arm B by inserting bolts E with washers F ,nuts G
through the pre-drilled holes on the arm and the pre-drilled holes on the
back. Repeat step for the other side arm B.
STEP 1
Tighten all the bolts with the wrench and the allen wrench,and turn the bench
to the upright position. The plate in the middle of the seat can be pulled up
and fixed as a small table. Your bench is now ready for use, so relax & enjoy!
Maximum Loads
WARNING
This item is only suitable within the specified maximum load-bearing. Heavier
loads than the indicated load capacity may cause instability, resulting in
possible injuries.
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
Use of furniture polish is not necessary.
Should you choose to use polish, test first in an inconspicuous area.
Using solvents of any kind on your furniture may damage the finish.
Never use water to clean your furniture as it may cause damage to the finish.
Liquid spills should be removed immediately. Using a soft clean cloth, blot
the spill gently. Avoid rubbing.
Check bolts/screws periodically and tighten them if necessary.
Further advice about wood furniture care
It is best to keep your furniture in a climate-controlled environment.
Extreme temperature and humidity changes can cause fading, warping, shrinking
and splitting of wood.
It is advised to keep furniture away from direct sunlight as sun may damage
the finish.
Proper care and cleaning at home will extend the life of your purchase.
Following these important and helpful tips will enhance your furniture as it
ages.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>