FS A12SA Amdt.A Voice Gun Electronic Megaphone User Manual
- June 12, 2024
- FS
Table of Contents
Voice Gun electronic megaphone
A12SA Amdt.A
ref. 2020118-01
FEDERAL SIGNAL VAMA, S.A.
C/Dr.Ferrán,7(08339)VILASSAR DE DALT – SPAIN
Tel: (34) 93.741.79.00
Telefax: (34) 93.753.03.62
WEB: www.fedsigvama.com
C:\ ARCHIVO\ DOCUMENT\ VARIOS
REF. DOC.91472002
F.U.R.: 24/02/22 REVISIÓN 7
A12SA Amdt.A, Voice Gun electronic megaphone Ref. 2020118-01
Specifications
Output power: 16 W
Current consumption: 160-200 mA
Voltage: 12 V, 8 AA batteries.
Amplifier: 3-stage, Class B output.
Speaker: Re-entrant horn and driver type.
Microphone: Noise-cancelling, magnetic.
Megaphone material: Lexan, red.
Carrying strap: Nylon, adjustable.
Weight (with batteries): 1.4 kg
Operation
GENERAL DESCRIPTION
The Federal Signal Vama Voice Gun (Model A12SA Amdt.A ) electronic
megaphones are designed for long, trouble-free service and simple operation.
The following should be observed to obtain maximum results:
A. Operating power for the electronic megaphone is supplied by eight AA
size batteries (not supplied). To install batteries, apply slight pressure
with thumb against battery cartridge at bottom of handle. Remove locking thumb
screw (if tight, screw may be started with a thin coin). Remove cartridge. All
batteries should be placed in position with the small copper battery tip
pointing away from the springs at the top and bottom of the cartridge.
Standard AA size alkaline batteries are recommended for greater volume and
life.
CAUTION
Do not use mercury cells. Polarity of mercury cells is reversed and damage to
the instrument May result.
B. The Class B amplifier draws very little current, even with the trigger
button depressed, except when actually speaking into the microphone. This
results in excellent efficiency and long battery life. In instances where the
electronic megaphone is used for short periods a few times a week, batteries
may last from six months to one year. Batteries should be replaced at least
yearly to avoid possibly exceeding their shelf life.
WARNING
Your hearing and the hearing of others, close to the electronic megaphone, could be damaged by loud sounds. This can occur from short exposures to very loud sounds, or from longer exposures to moderately loud sounds. For hearing conservation guidance, refer to community, state, or local recommendations.
Operation of the electronic megaphone is very simple. The following steps should be observed to obtain maximum results.
A. The electronic megaphone is operated by simply pressing the trigger
button and speaking into the microphone. The button should be depressed only
when actually speaking.
B. Hold the electronic megaphone with one hand. Do not place other hand
around mouthpiece. The unit has been designed with a crisp response to
increase intelligibility, particularly when used under noisy conditions. If
operated in a small empty room, a slight ringing sound may be noticed.
C. For simplicity, no external volume control is used. Volume is
controlled entirely by voice intensity. FOR BEST RESULTS AND UNVARYING SOUND
REPRODUCTION, LIPS SHOULD BE PLACED IN CONTACT WITH MICROPHONE HOUSING.
D. For maximum intelligibility and effectiveness, be sure the open bell
side of the Voice Gun is facing those you are speaking to.
NOTE
Volume is preset at the factory and normally should not need readjustment. If
and when necessary, it can be adjusted by removing rubber plug on horn at rear
of handle and inserting small screwdriver. Turning control to the left
decreases microphone sensitivity and turning to the right (clockwise)
increases sensitivity. Control should be set just below the point of feedback
under existing conditions.
Rubber plugs should be reinserted, forcing it in place with a small
screwdriver.
- microphone
- Volume adjustment plug
- batteries cartridge
- speaker
- trigger button
Service and Maintenance
CLEANING
Molded parts of the Voice Gun electronic megaphone are made of exceptionally tough and rugged material. When cleaning molded parts, use a damp cloth and mild detergent. Do Not use solvent or strong cleaning agents.
BATTERY REPLACEMENT
Power is supplied by eight AA size batteries. At least 1500 to 3000 ten-second
messages should be expected from one set of batteries.
It is recommended that batteries be replaced yearly, even though still
functioning. For longer shelf life and much longer operating life, we
recommend use of alkaline batteries.
To remove batteries, proceed as follows:
A. Apply slight pressure with thumb against battery cartridge at bottom
of handle.
B. Remove locking thumb screw. If tight, screw may be started with a thin
coin.
C. Remove cartridge.
D. All batteries should be placed in position with the small battery tip
pointing away from the springs at the top and bottom of the cartridge (see
figure).
Figure 1. Batteries cartridge.
TROUBLESHOOTING
A. No sound reproduced. No “click” heard in speaker when switch button is depressed. Proceed with the following steps:
- Check for dead or extremely weak AA 1.5V batteries or one or more dead cells.
- Check for proper installation of batteries in cartridge.
- Reinstall cartridge and batteries in handle.
If the previous checks do not reveal trouble, the amplifier assembly is defective and should be replaced or repaired.
REPARATION SERVICE
Should the electronic megaphone not function, or not function properly after proper installation of good batteries, it is suggested that the factory be contacted. Describe briefly what the difficulty seems to be. Communications should be addressed to:
Service Department
Federal Signal Vama
National telephone: 93.450.69.87
International telephone: 34.450.69.88
C/Dr. Ferrán, 7 (08339), Vilassar de Dalt
Spain
Figure 2. Spare parts electronic megaphone A12SA Amdt.A ref. 2020118-01.
Spare parts
No | ref. VAMA | Description | ref. FSC | Q |
---|---|---|---|---|
1 | 144A105-01REC | Clip & dee,5/8 in,fed | Z144A105-01 | 1 |
2 | 7000A162-10 | Screw 8-32 x 5/8″ | Z7000A162-10 | 1 |
3 | 288B014REC | Strap shoulder | Z288B014 | 1 |
4 | 7017A009-16 | Screw, shoulder, Brass, 6-32 | Z7017A009-16 | 1 |
5 | 200B177-11REC | Assy, cartridge, red lexan | Z200B177-11 | 1 |
6 | 228A016-01REC | Bumper, plug, rubber | Z288A016-01 | 1 |
7 | 137B115REC | Microphone, voice gun | Z137B115 | 1 |
8 | 170B155-11REC | Housing, microphone, red lexan | Z170B155-11 | 1 |
9 | 7011A046-12 | Screw 10-32 X 5/8″ | Z7011A046-12 | 3 |
10 | 170D112-11REC | Horn assy, red lexan | Z200C167-11 | 1 |
11 | 132C107FREC | Driver w / stud adaptor | Z132C107F | 1 |
12 | 91261227-01 | PC board A12SA | Z200C507F | 1 |
13 | 7000A025-06 | Mach, screw, 8-32 x 3/8″ | Z7000A025-06 | 1 |
14 | 7000A070-10 | Handle screw, 10-32 x 1/2″ | Z7000A160-08 | 1 |
15 | 288B013REC | Handle, gasket | Z288B013 | 1 |
16 | 154D106-11REC | Handle, red lexan | Z154D106-11 | 1 |
17 | 200A176 | Switch plate assembly | Z200A176 | 2 |
18 | 288A010-11 | Switch button red | Z288A010-11 | 1 |
19 | 200A173 | Contact plate assembly | Z200A173 | 1 |
20 | 7000A025-06 | Screw, 8-32 x 3/8″ | Z7000A025-06 | 1 |
21 | 7000A356-14 | Screw fixation driver | Z7000A356-14 | 1 |
22 | 231A111 | Post. Threaded | Z231A111 | 1 |
23 | 288A015REC | Gasket driver | Z288A015 | 1 |
24 | 9027282 | Flat washer M05 | Z9027282 | 3 |
25 | 231A110REC | Stud adapter | Z231A110 | 1 |
26 | 8146A282-01 | Name plate FS | Z8146A282-01 | 1 |
27 | 7011A011-10 | Screw Phil tip | Z7011A011 | 1 |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>