S5850-24S2Q Switch Reset and Recovery System Configuration Guide

Model: S5850-24S2Q

CONFIGURATION GUIDE

1. Configuration Considerations

Table 1 products and versions for example.

Series

| Product
---|---
S5850 series|

S5850-24S2Q

2. Network Topology

1. Console line
2. RJ45 line
3. CON
4. Switch 1
5. PC

3. Operation Steps

3.1. Connection Equipment

According to the way of networking topo to connect PC and switch to network

cable and Console. One end of the RJ-45 network cable is connected to the PC NIC, and the other end is connected to the SW’s network port. Connect one end of Console line USB to PC’s USB interface, and the other end of RJ-45 is connected to console interface of front panel of switch.

3.2. Download Configuration Software

After the connection is completed, there we recommend the super terminal,

putty or Secure CRT tool to configure the switch.

3.3. Switch on and Use Login Software

Energizing the switch, then open the installed login software, select the

serial port of login mode, port through the device manager to determine. Baud rate :115200, Data bits: 8, Parity: None, Stop bits: 1. (Reference below)

NOTE: COM Number can be viewed through device manager. (right click on my computer.>manage>device manager>port (COM and LPT). If it displays an unrecognized USB device, please download and install the corresponding driver.

3.4. Restoration System

*Set PC ip address

*Then prepare tftp

*After the connection is completed, power the switch (or power off and restart). During startup, when a countdown prompt appears to enter Uboot mode (as shown in Figure 2), press “Ctrl + B” to enter Uboot mode.

*Set ip address
bootrom:> setenv ipaddr 192.168.1.1
bootrom:> saveenv
bootrom:> setenv netmask 255.255.255.0
bootrom:> saveenv

*Specify the IP of the TFTP server
bootrom:> setenv serverip 192.168.1.2
bootrom:> saveenv
bootrom:> setenv gatewayip 192.168.1.2
bootrom:> saveenv

*Load the mirror boot system from the TFTP server
bootrom:> boot_tftp FSOS-S5850-Series-v6.2.27.r.bin

*Enter the system.
……….
Loading startup configuration file…… Done!

Mon Jan 1 00:01:20 UTC 2001
Ready to service!
Switch> enable
Switch#

NOTE:

1. Attention should be paid to the following issues when loading images through TFTP servers :
   • Ensure that you are properly configured as a TFTP server;
   • Ensure that Switch routes to TFTP servers are accessible. If there is no router for routing communication between subnetworks, switches and TFTP servers must be in the same network;
   • Make sure that the configuration files you want to download are in the correct directory on the TFTP server;
   • Download operation to ensure that the file’s permissions are set correctly.

2. After successfully entering the system, it is still necessary to download the upgrade package from the TFTP server to the switch system folder according to the routine process. And specify the upgrade package as the next load project for the system to start. For more information, please refer to the S5850-24S2Q Switch FSOS Software Upgrade Guide.

3.5. Switch to Factory Reset

Switch# clear startup-config
Are you sure to delete startup configuration file? yes/no: yes
Switch# reboot
Building configuration…
Startup config file is not exist. Copy running config to Startup config?

Reboot system? [confirm]

www.fs.com

References

• FS.com - Data Center, Enterprise, Telecom
• FS.com - Data Center, Enterprise, Telecom

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>