Diso MH-801 TWS Bluetooth Earbuds User Manual
- June 12, 2024
- Diso
Table of Contents
Diso MH-801 TWS Bluetooth Earbuds
Packing List
Product Parameters
- Bluetooth Version: V 5.2
- Distance: 10 m
- Playing Time: 5 hours
- Charging Time: 1 hour
- Total playing time with case: 20 hours
- Rated Input of Earphones: DC 5V=25 mA
- Rated Input of Charging case: DC 5V=280 mA
- Case charges earphones: >3 times
- Speaker Unit : 14.2mm moving coil
- Earphone Battery: 25 mAh
- Charging Case Battery: 300 mAh
- The earphone battery life time is the actual data based on 50% volume of the lab test, battery life and charge cycles vary by use and setting.
Operating Instructions
Use for the first time
-
Step 1-Charge earphones and case First, ensure that earphones in the case before charging both case and earphones. A Type-C cable can be used to charge case; Wireless charge mode (optional): Use a wireless charger to charge case. Place case right facing up. During charging, case red light is on. The green light keeps on when case is fully charged
-
Step 2 -Turn on and pair earphones Open case, green light will go on and earphones automatically enter Pairing status.
-
Step 3 -Connect to Bluetooth device Turn on Bluetooth settings, and choose “Diso 801” to establish a connection.
-
Step 4 -Turn off earphones Place earphones in the case and close lid.
Notes:
- The earphones are out of power if they do not power on automatically when case is opened. Please charge case and earphones.
- When earphones are disconnected from Bluetooth device more than 5 minutes, they will power off automatically.
Connect a New Device
- Open case while keeping earphones inside. Press and hold the button on the case for 3s until white light blinks, earphones will enter Pairing status.
- Turn on device’s Bluetooth, then choose “Diso 801” to establish a connection.
Function Operation
Problems and solutions
Safety Operation
Important safety information
Please careful use earphones and case with caution. Because they contain high-
sensitivity electronics (including batteries), falling off, incineration,
puncturing, compressing, disassembling, or exposure to high temperature,
liquid, or high concentration industrial chemicals (including close proximity
to vaporous liquefied gases such as nitrogen) may cause damage or injury. If
the earphones or charging case are damaged, do not use them.
Batteries
Do not attempt to replace earphones or case batteries on your own hands. You
could damage the batteries, resulting in overheating or physical injury.
Hearing impairment
Listening to music at a high volume may cause irreversible hearing impairment.
Before playing audio, please check the volume. Avoid listening to music at
high volumes to
avoid probable hearing impairment.
Foryour safety
It is not recommended to use earphones while driving. It is prohibited in some
regions. Do not use earphones while driving or performing any other activity
that needs concentration. Do not use Bluetooth earphones while driving, riding
a bicycle, or on the road.
Choking hazard
The earphones and charging case contain tiny pieces that could cause a choking
hazard and other personal damage. Please keep them out of children’s reach.
Interference with medical devices
Some earphones and charging case components may emit electromagnetic fields
when used with the radio. Magnets are also included. These magnetic fields and
electromagnetic fields may interfere with pacemakers, defibrillators, and
other medical devices. Please maintain a safe distance between medical devices
with earphones and case.
Skin irritation
If earphones are not properly cleaned, they can cause ear infections. Please
clean earphones on a regular basis. Keep all holes dry and avoid using any
aerosol, solvent, or abrasive. If you have a skin condition, stop wearing
earphones and see a doctor if it persists.
FCC STATEMENT
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However. there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
NOTE: This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitted The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Warranty Card
- Customer name:
- Contact number:
- Contact address:
- Product item:
- Problem description:
Warranty instructions:
Thank you for purchasing our products. To protect your legal rights, please
read the following items: This card is a product warranty certificate. Please
provide card together with the product to our company for any after-sales
repair. This warranty card is only valid for product use within the scope of
the following: CD The company products obtained through legitimate and formal
channels. @ Non-human damaged products, including but are not limited to
unauthorized removal, unloading, improper use, natural disasters and so on. @
Does not exceed the product warranty period of 1 year.
DISO INC
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>