MINN KOTA Riptide Ulterra Trolling Motor User Guide
- June 12, 2024
- MINN KOTA
Table of Contents
RIPTIDE ULTERRA QUICK START UP
GUIDE
GETTING STARTED
POWER ON
The Riptide Ulterra trolling motor must be powered “on” manually. The remote
will not turn the motor on. The power button is located on the base of the
motor. Pressing the power button will turn on Riptide Ulterra. The red STATUS
light and the green SYSTEM READY light will both be illuminated when powered
on. POWER OFF
To power off Riptide Ulterra, press and hold the POWER button approximately
three seconds, until the green light turns off . Riptide Ulterra has an auto-
shut off as well. It will automatically power off after 1.5 hours of inactivity
in the stowed position.
STATUS LIGHT
The red STATUS light indicates:
Solid: Motor is stowed
Flashing: Motor is stowing/deploying
Off : Motor is deployed or off
SYSTEM READY LIGHT
The green SYSTEM READY light will remain lit while Riptide Ulterra is
operating.
If the green light does not remain illuminated after power up, this is an
indicator of insufficient voltage/power.
WARNING:
When the motor is powered off while off the ramps, never turn the lower unit of the motor manually (by hand). This will aff ect the alignment of the motor and cause it to stow improperly.
FOR A COMPLETE LISTING OF ULTERRA FAQS, VISIT MINNKOTAMOTORS.COM/RIPTIDEULTERRA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>