belluscura X-PLOR2 Portable Oxygen Concentrator Installation Guide
- June 12, 2024
- Belluscura
Table of Contents
CARTRIDGE REPLACEMENT
Installation Guide
X-PLOR2 Portable Oxygen Concentrator
Cartridge Replacement
PART 1 Removing Cartridge.
|
---|---
Turn off the X-PLOR® by pressing the power button for 2 seconds.| Remove the
X-PLOR from the carrying bag, if applicable.
|
Remove the battery from the X-PLOR.| Place the X-PLOR on its side to access
the underside of the POC.
|
Pull the cartridge out of the POC by pulling on the cartridge pull handle.|
Remove the cartridge completely from the X-PLOR and throw away.
Turn sheet over to continue to step 2.
PART 2 Installing Cartridge.
|
---|---
Remove cartridge from mylar bag. The new cartridge has a dust cap on top.
Remove the dust cap. Make sure there is no dust or debris where the dust cap
was located.| Insert new cartridge top first into the X-PLOR. Do not leave the
cartridge
ends exposed; the cartridge should be inserted into the X-PLOR as soon as
the used cartridge is removed.
|
Push the cartridge into the X-PLOR so it is fully inside.| The cartridge pull
handle should lay flat once the cartridge is secured.
|
Connect charged battery to the X-PLOR.| Turn on the X-PLOR by pressing the
power button for 2 seconds. Set the flow setting to your prescribed setting
and use normally.
XPLOROxygen.com
LBL 5026-03
©2022 Belluscura LLC. All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>