xpr PXP-CY-BT-MF-IP54, PXP-CY-BT-MF-IP66 Mifare Electronic Knob Module User Guide
- June 12, 2024
- xpr
Table of Contents
xpr PXP-CY-BT-MF-IP54, PXP-CY-BT-MF-IP66 Mifare Electronic Knob Module
SPECIFICATIONS
- Up to 16,000 key/locking authorizations can be stored
- Up to 65, 000 readers per site (doors or rooms, please refer to the Key Manager manual)
- Up to 423 events registered in the reader memory
- Up to 16 configurable holidays
- 255 door groups
- 1695 blacklist cards
- Door pulse time can be programmed from 1 to 15 seconds or toggle
- No cabling required
- 2 Lithium batteries CR2 3V
- Battery life cycle: up to 40.000 operations or 2 years, depending on the usage, environment and battery condition
ASSEMBLY
Remove the fixing screw of the existing cylinder and dismantle the current
cylinder.
Push in the PXP-CY-BT-MF cylinder casing and fasten with fixing screw. Tighten
the fixing screw by hand, do not use a battery-op-erated screwdriver with a
high torque.
The cylinder body must not exceed by more than 1 to 3mm outside its enclosing
fitting, but should not be sunk completely in the upholstery neither.
The electronic knob is mounted onto the cylinder casing by inserting and
turning at the same time.
BATTERY REPLACEMENT
Hold the battery change card in front of the knob module – the knob module
gets into battery change position. Before this step, it may be necessary to
‘wake up’ the knob module by turning it.
Press in the now the unlocked sleeve-locking pin of the knob module with the
Battery change tool and simultaneously pull out the sleeve.
Remove empty batteries and insert the new batteries, paying attention to the
polarity.
Declaration of CE Conformity
XPR declares herewith that the device is compliant with the basic requirements
and the relevant rules in directives 2014/53/EU and 2011/65/EU. The
declaration of CE conformity is available at:
https://www.xprgroup.com/norms/
BATTERY REPLACEMENT
- RFID frequency: 13.56 MHz
- Radio frequency: 2.45 GHz
- Transmission power: 4mW
- RFID field strength: according to EN 300 330
- Batteries: 2 pieces, type CR2 Lithium 3V
ASSEMBLY
