RYDEEN BL01 License Plate Bracket for MINy and MINy HD Instruction Manual

Table of Contents

Part Number: BL01

Product Name: License Plate Bracket for MINy and MINy HD

Start by ensuring that you have all the necessary tools and equipment for installation, including a screwdriver and the license plate bracket BL01.
Locate the desired position on your vehicle’s front bumper to mount the license plate bracket.
Clean the mounting area thoroughly to remove any dirt or debris that may affect the adhesive or screw attachment.
If using adhesive, peel off the backing from the adhesive pad on the back of the license plate bracket. Press firmly onto the cleaned mounting area and hold for a few seconds to ensure proper adhesion.
If using screws, align the pre-drilled holes on the license plate bracket with the corresponding holes on the mounting area. Insert the screws through the holes and tighten them using a screwdriver until secure.
Once the license plate bracket is securely attached, place your vehicle’s license plate onto the bracket. Ensure that it is centered and aligned correctly.
If necessary, use additional screws or adhesive to secure the license plate onto the bracket for added stability.
Double-check the attachment to ensure that the license plate bracket is securely mounted and the license plate is properly fastened.

Please refer to the full user manual for any additional information or troubleshooting steps.

Bracket Assembly

If not already completed, remove the backing from the supplied adhesive strips and affix them to the back of the mounting bracket. Position one each on the back of the bracket between each license plate eyelet and the center hole on the bracket.
On the camera, remove the universal mounting bracket by removing the screw that holds it to the camera. (A hex wrench is provided for this purpose.)
Attach the camera to the license plate bracket by lining up the (4) bracket eyelets with the corresponding holes at the base of the camera. (Ensure that the arrow on the top of the camera is facing up.) Apply washers to the two long screws provided with the bracket kit.
With the front of the bracket facing you, insert the screws into the bracket holes on the right side of the camera and tighten with the hex wrench.

Bracket Installation

Remove the vehicle license plate. Use the assembled bracket as a template to determine the best position to drill the wire pass-through hole by aligning the eyelets on the bracket with the top two license plate holder eyelets. Important: Check behind the intended drill area to ensure that there are no wires or other obstructions.
Drill a hole large enough to pass the camera connector. Use a grommet (not supplied) or other means to cover the hole’s edges and protect the cable from shorting or fraying against the metal.
Route the connector through the hole and pull any excess cable through. Clean the area where the bracket is to be mounted. Placing the bracket in its intended mounting position, remove the remaining backing from the adhesive strips and secure the bracket to the vehicle, ensuring that its eyelets are aligned with those that secure the license plate.
Replace the license plate and insert the holding screws.

In most cases, the camera angle will not need to be adjusted.
However, if adjustments are necessary, remove the camera from the mount and use pliers to carefully bend the bracket to the desired angle. Replace the camera.

Rydeen Mobile Electronics