iHome iBT700 PlayPro Bluetooth Mono Wireless Speaker User Manual
- June 12, 2024
- iHome
Table of Contents
iHome iBT700 PlayPro Bluetooth Mono Wireless Speaker
Buttons Using
CHARGING THE SPEAKER
- CHARGE UNIT BEFORE USE ABOUT 4 HOURS
INDICATORS
LED STATUS INDICATORS
- Blue LED = Bluetooth Status
- Red LED = Battery Status
BATTERY STATUS
- RED: charging (slow blink)
- OFF: fully charged
- RED: low battery (fast flash)
BLUETOOTH STATUS
- BLUE pairing(flashing)
- BLUE connectedtoBluetooth
SPLASHPROOF COVER
- Before using near water, make sure the splashproof cover is completely flush with the unit.
- Press along the entire edge of the cover until it is securely in place.
TRUE WIRELESS PAIRING
TRUE WIRELESS PAIRING (TWS)
(REQUIRES 2 SPEAKERS)
- Pair one iBT700 unit to your device via Bluetooth.
- Power on the second iBT700 unit.
- Press and hold the Vol + and Play Button for 2 seconds on each unit (unit would have a prompt tone).
- When both units are linked, will announce ‘Left Channel’, ‘Right Channel’ respectively.
- Both units will link TWS automatically next time both units are powered on within 20 sec.
- To remove TrueWireless pairing, press & hold Bluetooth Pairing button for 10 seconds.
BATTERY
INTERNAL RECHARGEABLE LITHIUM-ION BATTERY
This device uses an internal non-replaceable rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it for an extended period of time and try resetting the unit.
WARNING/DISPOSAL OF UNIT
Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:
- Never dispose of used batteries/electronics with ordinary solid wastes, since they may contain toxic substances.
- Always dispose of used batteries/electronics in accordance with the prevailing community regulations.
- Many electronics retailers now recycle batteries and other electronic components at no charge. To find a drop-off location near you, visit www.call2recycle.com
GENERAL BATTERY PRECAUTIONS
- Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.
- Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances.
- Avoid charging a rechargeable battery when the temperature is not within 5°C – 35° C (41° – 95° Fahrenheit).
- Never expose a battery to any liquid
- Never expose a battery to excessive heat such as direct sunlight or fire. Never use a battery pack in an unventilated vehicle where excessive internal temperatures may be encountered.
- Always keep batteries out of the reach of infants and small children.
IMPORTANT SAFETY INSTRUCTIONS
Please heed all warnings, read and follow all instructions and keep these instructions handy for future reference.
- Unplug unit and clean only with a damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit.
- Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
- Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this product during lightning storms or when unused for long periods of time.
- Damage Requiring Service – This product should be serviced by qualified service personnel when:
- The plug has been damaged
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally.
- No naked flame sources, such as lighted candles, should be placed on this product.
- Attention should be drawn to the environmental aspects of battery disposal.
- This product is suitable for use in tropical and or moderate climates.
WARNING
- Do not dispose of batteries in the household trash or fire.
- The mains plug of the power adaptor is used as the disconnect device, it shall remain readily operable.
- If the unit is to be unused for an extended period of time, such as a month or longer, charge the unit fully before storage.
- Always use a UL/ETL-certified charging adapter (not included), and the supplied USB charging cable.
FCC STATEMENT
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio TV technician for help.
ISED Information
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This device contains license-exempt transmitters)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device complies with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Warranty
- 1 Year Warranty
For questions, full instructions, warranty, and additional safety information, please scan the QR code or visit: www.ihome.com/help/ibt700
© 2023 SDI Technologies, Inc.
All rights reserved
Printed in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>