BaBylissPRO BABTT053T Tourmaline Titanium 1500 Dryer Instruction Manual
- June 9, 2024
- BaBylissPRO
Table of Contents
BABTT053T Tourmaline Titanium 1500 Dryer
Instruction Manual
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic
safety precautions should always be taken, including the following:
READ ALL INSTRUCTIONS BEFORE USING. KEEP AWAY FROM WATER.
DANGER – Any appliance is electrically live even when the switch is off.
To reduce the risk of death or injury by electric shock:
- Always unplug appliance immediately after using.
- Do not use while bathing or in the shower.
- Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not place in, or drop into, water or other liquid.
- If an appliance falls into water, unplug it immediately. Do not reach into the water.
WARNING – To reduce the risk of burns, electrocution, fire, or injury to persons:
- This appliance should never be left unattended when plugged in.
- This appliance should not be used by, on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped, damaged, or dropped into water. Return the appliance to place of purchase for examination and repair.
- Keep the cord away from heated surfaces. Do not pull, twist, or wrap line cord around dryer.
- Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and other debris.
- Never use while sleeping.
- Never drop or insert objects into an opening.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord to operate dryer.
- Do not direct hot air toward eyes or other heat-sensitive areas.
- Air outlet grille and attachments may be very hot during use. Allow them to cool before handling.
- Do not place appliance on any surface while operating.
- While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
- To prolong the life of the dryer, keep filters clean of hair and dust.
- Do not use with voltage converter.
- Be sure dual voltage selector is in correct voltage position before operating. Before plugging in, read the information about dual voltage contained in this instruction section of this manual.
- This appliance was set at the factory to operate at 125 volts. Refer to Additional Information section of this manual for conversion to 250 volts operation.
SAVE THESE INSTRUCTIONS OPERATING INSTRUCTIONS
This appliance is intended for professional use. Use on Alternating Current
(60 hertz) only.
Standard dryers are designed to operate at 110125 or 220-250 volts A.C. This
appliance has a polarized plug (one blade is wider than the other). As a
safety feature, this plug will fit into a polarized outlet only one way. If
the plug does not fit fully into the outlet, reverse the plug. If it still
does not fit, contact a qualifiedelectrician. Do not attempt to
defeat this safety feature.
CHECK ALCI SAFETY FEATURE EVERY TIME YOU USE DRYER.
This hair dryer is equipped with an Appliance Leakage Circuit Interrupter
(ALCI), a safety feature that renders it inoperable under some abnormal
conditions, such as immersion in water. To make sure the ALCI is functioning
properly, perform the following test: The purpose of this test is to allow you
to make sure the exclusive water sensing system (ALCI) is working.
- Plug in hair dryer and press test button on plug (see appropriate diagram).
- Hair dryer will stop working. There will be an audible click and reset button will pop out.
- To reset ALCI with a reset button: Unit should be unplugged. Then push reset button in, and reinsert plug into outlet.
- If ALCI is not functioning properly, return hair dryer to place of purchase.
- It is important that if immersion occurs, this unit be brought to a service center. Do not try to reset.
- Be sure to repeat test every time you use hair dryer to confirm ALCI is operational.
- Should the dryer go off and the ALCI reset button pop up during use, this could indicate a malfunction in the dryer. Remove plug from outlet and allow the dryer to cool. Push the reset button in and reinsert plug into outlet. Dryer should function normally. If not, return it to a Babyliss Pro Service Center for examination and repair.
SUPER STYLING GUIDE
Your best looks begin with a good haircut that’s well maintained. Always treat
hair well with superior quality shampoos, conditioners, and finishing
products.
DRYING BASICS
- Shampoo and condition hair with products of your choice. Rinse thoroughly. Towel-blot hair to remove excess moisture. Section hair. Using the dryer along with your styling brush, direct hot air through one section of hair at a time. Move dryer steadily across each section so that the hot air passes through hair. Direct airflow at hair, not scalp.
- Keep dryer’s air intake vents unobstructed and free from hair while drying.
- To avoid overdrying and possible damage to hair or skin, do not concentrate heat on one section for any length of time. Keep dryer moving as you style.
- For quick touch-ups between shampoos, dampen hair with a mist of water before styling with the dryer.
- When using your dryer to create curls and waves, dry hair almost completely on a warmer temperature setting, then finish styling with cooler air.
- This dryer includes a concentrator attachment. Use the attachment when you need drying power in a small area (such as a curl or a wave), or when you want to relax curly hair.
TOURMALINE TITANIUM TECHNOLOGY
Your Tourmaline Titanium dryer has many benefits. Titanium is an exceptional
conductor of heat and is stable in ultra-high temperatures. The Titanium
technology uses micro particles of titanium that provide the ultimate heat
performance for beautiful, healthy hair results. Titanium yields maximum far-
infrared heat – penetrating the hair from within for gentle drying without
damage.
Titanium emits negative ions in their most beneficial form for faster drying,
locking in hair’s own natural moisture. This Toumaline Titanium dryer will
give your hair a smooth, silky shine while eliminating frizz.
BODY & VOLUME
To create extra volume, turn head upside down while drying. Position the
airflow toward the roots for maximum lift. When hair is dry, gently toss head
back and brush hair into place. STRAIGHTENING
Work with hair in sections when creating a super straight look. Using a large
round brush (approximately 2″ in diameter), hold hair taut in each section and
bend ends slightly under as you dry. MAKING WAVES
Tousled, natural-looking waves are easily created by grasping hair at the
roots and scrunching between fingertips while drying. WARNING
THIS APPLIANCE IS DESIGNED EXCLUSIVELY FOR USE BY LICENSED COSMETOLOGISTS. GET
TO KNOW YOUR HAIRDRYER
Model BABTT053T
This message about.
- GROUND
- FAULT
- CIRCUIT
- INTERRUPTERS can save a life!
IF YOU MUST USE YOUR HAIR DRYER IN THE BATHROOM, INSTALL A GFCI* NOW!
Your local electrician can help you decide which type is best for you – a
portable unit thaplugs into the electrical outlet or a permanent unit
installed by your electrician. The National Electrical Code now requires GFCIs
in thebathrooms, garages, and outdoor outlets of all new homes.
WHY DO YOU NEED A GFCI?
Electricity and water don’t mix. If your hair dryer falls into water while
it’s plugged in, the electric shock can kill you… even if the switch is off. A
regular fuse or circuit breaker won’t protect you under these circumstances. A
GFCI offers you far greater protection.
A GFCI can save your life! Compared to that, the price is small! Don’t
wait…install one now!
- GFCI is a sensitive device which reacts immediately to a small electric current leak by stopping the flow of electricity.
ADDITIONAL INFORMATION FOR DUAL-VOLTAGE DRYERS
For use in the North America, the voltage selector switch should be placed in
the 125 position. For use in several countries overseas, the voltage selector
may need to be placed in the 250 position. Confirm the voltage available at
each overseas location before using the appliance. For connection to a
240-volt supply, use an attachment plug adapter of the proper configuration
for the power supply.
For 110-125 Volt Operation
Flick the dual voltage switch to the 125 position. In this position, the dryer
has two settings. It provides two speeds and two heats—low speed and low heat
on LO and high speed and high heat on HI.
For 220-250 Volt Operation
Flick the dual voltage switch to the 250 position. In this position, the dryer
has two settings. It provides two speeds and two heats — low speed and low
heat on LO and high speed and high heat on HI.
USER MAINTENANCE
Your dryer is virtually maintenance-free. No lubrication is needed. The dryer
must be kept clean for proper operating performance. When cleaning is needed,
unplug the cord, allow to cool and clean dust and lint from air intake
openings with a small brush or the brush attachment of a vacuum cleaner. The
outer surface of the dryer should be wiped clean with a damp cloth only.
Blocked or clogged air intake vents will cause the dryer to overheat. If
overheating occurs, an automatic safety device will shut the dryer or the heat
off to prevent damage or personal injury. If the unit or the heat cycles off,
turn the dryer off, unplug the cord, and allow the dryer to cool for 10 to 15
minutes before restarting. Make sure the air vents are clean.
CAUTION
NEVER allow the power supply cord to be pulled, twisted, or severely bent.
Never wrap the cord tightly around the dryer. Damage will occur at the high
flex point of entry into the dryer, causing it to rupture and short circuit.
Inspect the cord frequently for damage. Stop use immediately if damage is
visible or unit stops or operates
intermittently.
If the cord or dryer is damaged or does not operate properly, return it for
repair to place of purchase or an authorized Babyliss Pro service
representative only. No repairs should be attempted by the consumer.
STORAGE – IMPORTANT
When not in use, your dryer should be disconnected, allowed to cool and stored
in a safe, dry location, out of reach of children. Do not wrap line cord
around dryer. Allow the cord to hang or lie loose and straight at the point of
entry into the dryer.
LIMITED ONE-YEAR WARRANTY
BabylissPro will repair or replace (at our option) your unit free of charge
for 12 months from the date of purchase if the appliance is defective in any
workmanship or materials.
To obtain service under this warranty, return the defective product to the
service center listed on back, together with your purchase receipt and $15.00
for postage and handling. California residents need only provide proof of
purchase and should call 1-800-326-6247
for shipping instructions. In the absence of a purchase receipt, the warranty
period shall be 12 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED
TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS
WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL BABYLISSPRO BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of
special, incidental, or consequential damages, so the above limitation may not
apply to you. This warranty gives you specific legal rights, and you may also
have other rights, which vary from state to state.
SERVICE CENTER
BabylissPro
Service Department 7475 North Glen Harbor Blvd. Glendale, AZ 85307
©2016 BabylissPro
10BA112288
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>