VENTURE TFX-3TX Wireless Telephone Signaler User Manual

VENTURE TFX-3TX Wireless Telephone Signaler

Product Information

The TFX-303 is a user-friendly device designed to provide wireless communication between a line phone and a receiver. It features an LED indicator, lock lever, test button, and a battery compartment that uses a CR2032 battery. The device also includes a mounting plate for easy installation.

Product Usage Instructions

Battery Installation

1. Open the battery cover by releasing the lock and sliding it open.
2. Insert a CR2032 battery into the battery compartment.

Installation

1. Mark two holes on the wall using a pencil.
2. Drill two holes following the marking.
3. Fix the mounting plate to the wall using the provided screws.
4. Slide the transmitter onto the mounting plate until you hear a click sound.

Pairing

1. Put the receiver into pairing mode following the receiver manual.
2. Press the test button once on the transmitter.

Battery Low Indication
When the transmitter unit detects low battery voltage, the battery low information will be sent to the receiver for display.

Code Conflict
If the transmitter coding is the same as another transmitter, you must change the code. Follow these steps:

1. Open the transmitter cover.
2. Press and hold the test button.
3. Insert the battery while holding the button for 5 seconds.
4. The LED will flash 5 times when a new code is generated.

Note: Any modifications to this product will void the user’s authority to operate this equipment. This product complies with RoHS regulations.

Parts & Function

Battery Installation

Installation

Pairing

1. Make the receiver into the pairing mode follow the receiver manual
2. Press the test button once on the transmitter

Battery low indication
Once the transmitter unit detect battery voltage is low, The battery low information will be sent to the receiver for display

Code Conflict

• If the transmitter coding is the same as another transmitter you must change the code. When you have changed the code re-pair the transmitter is needed.
• Open the cover, Open the cover. Press and hold the test button, insert the battery whilst holding the button for 5 seconds. The LED will flash 5 times when a new code is generated

FCC Rules

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential the installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.
   Note : Modifications to this product will void the user’s authority to operate this equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>