THIRD REALITY 2BAGQ-3RVS01031Z Zigbee Vibration Sensor User Manual
- June 12, 2024
- THIRD REALITY
Table of Contents
2BAGQ-3RVS01031Z Zigbee Vibration Sensor
User Manual Vibration Sensor
Quick Start Guide
Introduction
Third Reality Zigbee Vibration Sensor can be used to detect the vibration and movement of objects, it is designed for indoor use only. It can be integrated into Amazon Alexa, SmartThings, Hubitat, Home Assistant and Third Reality App etc. through Zigbee protocol, it can be used to create routines like alerts of window breaks and washing machines/dryers monitoring etc.
Specification
| Operating Temp | 32 to 104 F(0 to 40 ℃) Indoor Use Only |
|---|---|
| Power Supply | 2 × AAA Batteries |
| Dimensions | 2.19″ × 2.20″ × 0.48″ |
( 5.56cm×5.59cm ×1.23cm)
Protocol| Zigbee 3.0
Siren Setting:
Senitivity Setting:
Setup
- Remove the plastic insulator to power the Vibration Sensor.
- When the sensor is powered up for the first time, it enters pairing mode automatically, and it exits pairing mode if not paired within 3 minutes, to put it into pairing mode again by pressing the reset button for 5 seconds.
- Follow the instructions of Zigbee hubs to pair the sensor. Turn on/off the beeping alarm with the single toggle switch, and set the sensitivity(4 levels) with the dual toggle switches.
Installation
Simply place the Vibration Sensor on top of the object to be monitored, or use double-sided tape to stick it anywhere as desired.
FCC Regulatory Conformance
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help important announcement
Important Note:
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Limited Warranty
For limited warranty, please visit
www.3reality.com/devicesupport
For customer support, please contact us at
info@3reality.com or visit
www.3reality.com
For help and troubleshooting related to Amazon Alexa, visit the Alexa app.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>