LEHNER VERSAND G2 Swivel Sweeper Instruction Manual
- June 4, 2024
- LEHNER VERSAND
Table of Contents
LEHNER VERSAND G2 Swivel Sweeper
Symbols and Signal Words
Signal words indicate hazards if the asso-ciated notices are not followed.
DANGER high risk, results in serious injury or death
WARNING medium risk, may result in serious injury or death
CAUTION low risk, may result in minor or moderate injury
NOTICE may result in risk of damage to material
Dear Customer,
We are delighted that you have chosen this cordless mop.
Before using the device for the first time, please read the operating
instructions carefully and keep them for future reference. If the device is
given to someone else, it should always be accompanied by these operating
instructions. They are an integral part of the device. The manufacturer and
importer do not accept any liability if the information in these operating
instructions is not complied with.
If you have any questions about the device and about spare parts /
accessories, please contact the customer service department via our website:
www.dspro.de/kundenservice
Intended Use
The device is intended to be used for the dry cleaning of all smooth surfaces. On no account should the device be used to suck up the following:
- liquids or wet substances (e. g. wet carpet shampoo)
- glowing ash, cigarette ends, matches, etc.
- inflammable or explosive substances
- pointed, hard objects such as large pieces of broken glass
Do not use the device on deep-pile carpets and rough floors (e. g. made of
concrete).
The device is for personal use only and is not intended for commercial
applications.
The device should only be used as described in the operating instructions. Any
other use is deemed to be improper.
The warranty does not cover faults caused by incorrect handling, damage or
attempted repairs. The same applies to normal wear and tear.
Safety Notices
WARNING: Note all safety notices, instructions, illustra-tions and technical data provided with this device. Fail-ure to follow the safety notices and instructions may result in electric shock, fire and / or injuries.
- This device may be used by children aged 8 and over and by people with reduced physical, sensory or mental abilities or a lack of experience and/or knowledge if they are supervised or have received instruction on how to use the device safely and have understood the dangers resulting from failure to comply with the relevant safety precautions.
- Children must not play with the device.
- Cleaning and user maintenance must not be carried out by children, unless they are older than 8 years of age and are supervised.
- Children younger than 8 years of age and animals must be kept away from the device and the charger.
- The charger must always be disconnected from the mains power when it is left unattended or cleaned.
- Only ever charge up the rechargeable battery using the charg-er (JF-DY095060E) supplied with the device. Do not use the charger that is supplied to charge up any other devices.
- Do not make any modifications to the device. If the device is damaged, it must be replaced by the manufacturer, customer service department or a similarly qualified person (e.g. special-ist workshop) in order to avoid any hazards.
DANGER – Risk of Electric Shock!
- Use and store the device only in closed rooms.
- Do not use or store the device in rooms with high humidity.
- Never immerse the device and the charger in water or other liquids and ensure that they cannot fall into water or become wet.
- Never touch the device and the charger with wet hands when the device is connected to the mains power.
WARNING – Danger of Injury!
- Keep children and animals away from the packaging material. There is a danger of suffocation.
- Danger of becoming stuck! Keep animals, hair, jewellery, wide clothing, fingers and all other body parts away from the suction opening of the device. They could become caught.
WARNING – Danger from Rechargeable Batteries
- Do not take apart the rechargeable battery. Protect the device from: fire, high tem-peratures of over 50°C, direct sunlight and sub-zero temperatures. The battery could ignite or explode. Do not store the device with a built-in battery in a vehicle where it might be exposed to extreme temperatures.
- Protect the inserted charger from persistent moisture. Load and store the recharga-ble batteries only in closed rooms. Do not use, charge or store it in rooms with high humidity.
- Do not charge up the device in the vicinity of highly flammable materials (curtains, textiles, etc.).
- Remove a dead battery from the device immediately. Clean the contacts before a new battery is inserted.
- If the battery leaks, do not allow your skin, eyes and mucous membranes to come into contact with the battery acid. There is a danger of burns. If you do touch battery acid, rinse the affected areas with abundant clear water straight away and seek med-ical assistance immediately.
- Do not use the device if the battery has leaked.
WARNING – Danger of Fire!
- Do not cover the device during operation in order to prevent it from catching fire. Do not insert anything into the openings of the device and make sure that they do not become clogged or covered.
NOTICE – Risk of Damage to Material and Property
- The device should only be used if it has been fully and correctly assembled!
- Use only original accessories from the manufacturer in order to guarantee that there is no interference that may prevent the device from working and to avoid possible damage.
- Do not place heavy objects on the device or the charger.
- Protect the device from heat, naked flames, sub-zero temperatures, persistent mois-ture, wet conditions and impacts.
Technical Data
Article numbers:
- 07019 (emerald green)
- 08495 (limegreen)
- 08531 (red)
ID of operating instructions : Z 07019_08495_08531 M DS V1 0821 mh
Device
- Model number: TK21006G2
- Voltage supply: 7,2 V DC, Li-Ion battery, 1500 mAh
- Power: 15 W
- Battery charge duration: 5 – 8 hours, depending on the charging status
Charger
- Model number: JF-DY095060E
- Input voltage: 100 – 240 V ~ 50 / 60 Hz
- Output voltage: 9,5 V DC, 600 mA
- Power: 5,7 W
- Protection class: II
Items Supplied and Device Overview
Check the items supplied for completeness and the components for transport damage. If you find any damage, do not use the device but contact our customer service department. Remove any possible films, stickers or transport protection from the device. Never re-move the rating plate and any possible warnings!
- Cleaning tool
- Battery
- Charger
- Cleaning foot
- Dirt container (on the bottom of the cleaning foot)
- Battery compartment
- Cover of the cleaning foot
- Bottom shaft piece
- On / Off switch
- Joint
- Middle shaft piece
- Top shaft piece
Not shown: Operating instructions
Charging Up the Battery
PLEASE NOTE!
- Only connect the charger to a plug socket that is properly installed and matches the technical data of the charger. The plug socket must also be readily accessible after connection so that the connection to the mains can quickly be isolated.
- Pull the charger out of the plug socket if an error occurs during operation or before a thunderstorm.
- It is essential that you charge up the battery fully before you first use the device in order to achieve the maximum charging capacity. If the battery is fully discharged during use, it must be fully charged up again before it is next used.
PLEASE NOTE: The battery needs approximately 8 hours to charge up on a first charge. The length of time required for subsequent recharging depends on the charging status of the battery in each case; if the battery is flat, it is approximately 5 hours.
- Insert the battery (2) into the charger (3) until you hear it engage. Make sure that the two arrows are pointing towards each other.
- Connect the charger to an easily accessible plug socket.
- Fully charge up the battery.
- Pull the charger out of the plug socket.
- Remove the battery from the charger by pressing together the two release buttons on the side of the battery and pulling out the battery at the same time.
Assembling the Device
- Plug the bottom shaft piece (8) onto the shaft piece of the cleaning foot (4). Make sure that the two arrows on the shaft pieces are pointing towards each other. When you push them together, press together the two locking lugs on the shaft piece of the cleaning foot. The locking lugs must then engage in the openings of the bottom shaft piece.
- Screw the middle shaft piece (11) onto the bottom shaft piece and the top shaft piece (12) onto the middle shaft piece.
- Insert the battery (2) into the battery compartment (6) on the bottom shaft piece. Make sure that the two arrows are pointing towards each other.
Use
PLEASE NOTE!
- Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
- When you lift up the device, always keep the cleaning foot horizontal so that no dirt can fall out of the dirt container.
- Switch the device off after each surface has been cleaned as this will considerably increase the operating time on each battery charge. Charge up the battery after use (see the “Charging Up the Battery” chapter).
- Move the On / Off switch (9) to the ON position to switch on the device. The brushes of the cleaning foot (4) start to rotate.
- Move the cleaning foot over the surface which is to be cleaned. The dirt is picked up by the rotating brushes and collected in the dirt container (5) on the bottom of the cleaning foot. If too much dirt blocks up the brushes, they may come to a standstill. In this case, move the On / Off switch to the OFF position, take the battery (2) out of the battery compartment (6) and clean the brushes (see the “Cleaning and Storage” chapter).
- Move the On / Off switch to the OFF position to switch off the device.
- Empty the dirt container after each use (see the “Cleaning and Storage” chapter – “Emptying the Dirt Container”).
Bending the Shaft The shaft can be bent up to an angle of 90° to make it easier to handle.
- Slide up the button on the side of the joint (10) and at the same time move the shaft towards the battery compart-ment (6). The angle is infinitely adjustable.
- Let go of the button to fix the shaft at the set angle.
Cleaning and Storage
PLEASE NOTE! Do not use any sharp or abrasive cleaning agents to clean the device. They could damage the surfaces.
- Make sure that the device is switched off.
- Remove the battery (2) by pressing together the two release buttons on the side of the battery and pulling out the battery at the same time.
- Empty the dirt container (5) (see the “Emptying the Dirt Container” section).
- Wipe down all parts of the device with a dry or damp, lint-free cloth.
- Remove dirt, hair and threads from the brushes in the cleaning foot (4) on a regular basis (see the “Cleaning Brushes” section).
- Store the device, the charger (3) and the battery in a dry, frost-free place which is not accessible to children and animals.
To make it easier to store, fold the side of the cleaning foot on which the magnet is located up towards the shaft.
Emptying the Dirt Container
- Hold the cleaning foot (4) over a dustbin.
- Open the dirt container (5) by pressing together the two catches next to the shaft. The flap of the dirt container will flip open immediately and the dirt will drop into the dustbin.
- Flip the dirt container shut. The catches must audibly engage.
Cleaning Brushes
As is the case with all cleaning equipment with rotating brushes, hair,
threads and other small parts collect on the cleaning brushes over time. We
recommend that the brushes are cleaned from time to time with the help of the
cleaning tool (1) supplied.
- To make the brushes easier to access, remove the cover of the cleaning foot (4) by sliding the two catches on the cleaning foot towards one another and taking off the cover.
- Remove any dust and dirt from the brushes with the help of the cleaning tool.
- Place the cover on the cleaning foot and fix it in place with the catches by sliding them away from one another.
PLEASE NOTE: A small magnet is located on the bottom shaft piece (8) and the cover in each case. When you insert the cover, make sure that both magnets are pointing to-wards each other.
Troubleshooting
If the device does not work properly, check whether you are able to rectify
the problem yourself. If the problem cannot be solved with the steps below,
contact the customer service department.
Do not attempt to repair an electrical device yourself!
Problem | Possible cause | Solution |
---|
The device only works slowly or does not start.
| The battery ( 2 ) is empty.| Charge up the battery.
The battery ( 2 ) is not placed in the battery compartment ( 6 )
correctly.| ****
Correct the fit of the battery.
The bottom shaft piece ( 8 ) and the shaft piece of the clean- ing foot ( 4 ) are not connected together correctly.| ****
Correct the fit.
The On / Off switch ( 9 ) is in the
OFF position .
| Move the On / Off switch to
the ON position.
The battery is not charging up.
| The battery ( 2 ) is not placed in the charger ( 3 ) correctly.|
Correct the fit of the battery.
The charger ( 3 ) is not inserted
correctly in the plug socket.
| Correct the fit of the charger.
The plug socket is defective.| Try another socket.
There is no mains voltage.| Check the fuse of the mains connection.
The device operates but does not pick up any dirt.
| The dirt container ( 5 ) is full.| Empty the dirt container.
Dirt particles will remain stuck to the carpet or will be too big / heavy to
be picked up by the device.| ****
Remove by hand.
During cleaning the device loses
some of the dirt and waste.
| The dirt container ( 5 ) is full.| Empty the dirt container.
The flap of the dirt container ( 5 )
is not shut correctly.
| Correct the fit of the flap.
Dirt has become trapped in the brushes.| Clean the brushes.
Disposal
- Dispose of the packaging material in an environmentally friendly manner so that it can be recycled.
- The battery should be removed before the device is disposed of and should be disposed of separately from the device at suitable collection points.
- This device is governed by the European Directive 2012/19/EU on waste electri-cal and electronic equipment (WEEE). Do not dispose of this device as normal domestic waste, but rather in an environmentally friendly manner via an officially approved waste disposal company.
Customer Service
DS Produkte GmbH Am Heisterbusch 1 19258 Gallin
Deutschland (Germany | Allemagne | Duitsland)
Tel.: +49 38851 314650*
Calls to German landlines are subject to your provider’s charges.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>