XZENT X-F285 Multimedia and Navigation Systems Instruction Manual

XZENT X-F285 Multimedia and Navigation Systems Instruction Manual

Change notes for SW v4.1 and DAB firmware version (V15-000A0A-01-0121-011B):

Note:
The version information can be found under SETTINGS > Others.
The DAB firmware version can be found in the DAB source > Settings.

• Navigation:
Improvement for the TPEG channel search for events and traffic flow data.
o iGO version 9.35.2.268605, Traffic settings > DAB+TEG must be switched on.
o GPS reception as well as DAB reception of a FREE-TPEG channel of the matching country according to GPS.
o During the cyclical TPEG reception, the DAB-DAB following function is restricted for the audio program.

• General:
o Correction of the Ford Steeringwheel PHONE-Buttons for pickup and hangup.
o Activation of the DAB program logo database.
o DAB source adjustment, new display for the background tuner, setting for the TPEG reading time.
It is recommended to leave <> set to <> when TPEG channel search was successful and messages are displayed. The <> setting should only be used if the DAB coverage is poor or the DAB audio program is not being used (e.g. other audio sources such as FM or USB are being heard). DAB-DAB Following and Station List updates will be executed less often when the device is longer busy with TPEG reading.

Step: 1 Download of SW and preparation of a USB flash drive for the update process:

Attention: in some rare cases, the USB-flash-drive may not be detected by the XZENT device. If one step fails, please re-check and re-use a different brand/manufacturer USB flash drive item and/or change the memory size (<1 GB, 2 GB, 4 GB …).
Do NOT download and execute (extraction) directly to PC.
Do not copy the multiple extracted files to your USB flash drive – copy the single archive file to the USB flash drive and extract it there.

Step 2: installing the software
Approximately required time for DAB/APP/MCU Update ~15 minutes (without preparation time).

DAB Firmware:
V15-000A0A-01-0121-011B

Step 4: Loading Factory Settings
Load factory settings from Setup > Others > Load Factory > OK
Your device is now ready for regular use if the full software has been successfully installed.

Remarks / Troubleshooting:

• The SW can only be completely installed if the USB-1 port was used.
• With the DAB FW update, a FULL SCAN can first be triggered on devices that have an empty station list. The FULL SCAN dialog and the DAB update dialog can overlap here. You can cancel the FULL SCAN without any problems to see the installation progress better.
• If an ERROR appears in a sub-step – the USB stick should be checked and replaced or redone (format, download, extract, copy).
• In case of an APP installation ERROR, the device can restart in a continuous loop until a USB stick with a correctly readable APP update is found. The device can be temporarily switched off or disconnected from the power supply until a working USB stick can be connected.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>