ROUSENSMART RS-CLT IOT Bus Coupler Instruction Manual
- June 13, 2024
- ROUSENSMART
Table of Contents
ROUSENSMART RS-CLT IOT Bus Coupler
The IOT Coupler RS-CLT is a device used for connecting and installing sensors in an Internet of Things (IoT) system.
Product Information
- Connection Mode: The connection mode is illustrated in the figure below.
- Installation Mode: The installation mode is shown in the figure below. During installation, follow the steps outlined below:
Installation Steps
- Remove the PG connector.
- Attach the product to the wall.
- Fix the four screws in turn.
- Reconnect the PG connector.
When installing the sensor, choose a location that meets the following criteria:
- No obvious shielding
- No corrosive liquid
- Close proximity to the sensor
Note: If you encounter any difficulties during installation, consult the dealer or an experienced radio/TV technician for assistance.
To ensure compliance with FCC’s RF Exposure guidelines, it is important to install and operate this equipment with a minimum distance of 20cm between the radiator and your body. Additionally, use only the supplied antenna for optimal performance.
This product is a data signal acquisition device in the IOT area, which is used to collect sensor data in the specified area. It has the features of wireless transmission, AD Hoc network, self-recovery from network disconnection, self-selection of optimal network path, self-rehabilitation from link failure, and supports hibernation and wake up. The product is made of aluminum alloy material, with waterproof and moisture-proof measures, so that it is suitable for the complex scene with harsh environment or strong interference, such as underground pipe gallery, tunnel, mine, factory, etc. Wireless transmission and AD Hoc network can flexibly add sensors and achieve project expansion. It supports 4-20mA current transmission and RS485 signal transmission mode, can adapt to the existing various sensors in the market.
Product parameters
- Frequency range: 2405-2480MHz
- Working voltage: 24 V DC
- Transmitted power: +20dBm
- Receiving sensitivity: -103dBm
- Transmission rate: 250kbps
- Analog input: 4～20mA*5
- Serial interface: RS485
- Antenna gain: 4.12dBi
- Protection grade: IP66
The connection mode is shown in the figure below:
The installation mode is as shown in the figure below：
During installation, first remove the PG connector, then attach the product to the wall, fix the four screws in turn, and finally reconnect the PG connector.When installing the sensor, choose a place with no obvious shielding, no corrosive liquid, and close to the sensor.
FCC
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>