EVA LOGIK ZW39 Z-Wave Smart Plug Installation Guide

Installation Manual
ZW39
Z-Wave Smart Plug
(Dimmer)
Z-Wave Network Configuration

Specifications:

Power: 120VAC, 60Hz
Loading: 500W
Frequency: 908.42MHz
FCC ID: OXGZW36
IC: 10460A-ZW36

Adding Device To Z-Wave Network for QR CODE

INTRODUCTION

The EVA LOGIK ZW39 is a Z-Wave enabled 500W  receptacle designed for most residential lighting and applications. It’s compatible with LED, halogen, incandescent.The ZW39 fully works with the Fibaro, Smartthings, Wink hub as well as allother certified Z-Wave controllers.
Plug the light you want to control into the Z-Wave Smartplug controlled outlet .
NOTE: Plug directly into outlet, do not use with extensioncords. Note: Your device may need to be within 100 feet of the controller to be included. If so, include the device to the network within 10 feet of the controller and relocate it to the desired position in your home. Be sure to refresh the network if the device is included in this manner.

Minimum brightness setting:

1. Quickly press the button 5 times (blue indicator flashes slowly), and the connected bulb is automatically adjusted to the minimum brightness currently.
2. Hold the button to adjust the brightness of the connected bulb, select the appropriate brightness and set it to the minimum brightness.
3. Quickly press the button 5 times to confirm the minimum brightness. Exit setting after the setting is completed (indicator flashes 3 times).

Maximum brightness setting:

1. Quickly press the button 10 times(blue indicator flashes slowly), and the connected bulb automatically adjusts to the maximum brightness currently.
2.  Hold the button to adjust the brightness of the connected bulb, select the appropriate brightness and set it to the maximum brightness.
3. Quickly press the button 10 times to confirm the maximum brightness. Exit setting after the setting is completed (the indicator flashes 3 times).
   Note: If no confirm in step 3, the setting mode will be exited after 10s and the adjusted bright ness value will not be saved.

Adding Device To Z-Wave Network

1. Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave network.
2.  Once the controller is ready to add your device, press the manual/ program button(A) on the  smart dimmer 3 times quickly. The white LEDwill blink quickly.
   Auto-add mode: LED will blink within 30 seconds after first plugged in.
   Now, you have complete control to turn your fixture ON/OFF or set dim levels according to groups, scenes, schedules and interactive automation programmed by your controller. If your Z-Wave certified controller features remote access, you can control your fixture from your mobile devices.
   Again: If you have issues with pairing/including, please move the device as close as possible to the hub and try again–you can move to your final location when completed.
   Note: If the manual button(A doesn’t light up after pressed 3 times, please reset the device: click the  button 2 times quickly then hold for at least 10seconds. This operation could be done when manual control is functional–single press can turn on/off the lamp.

To Remove The Device

1. Follow the instructions for your Z-Wave certified controller to remove a device from the Z-Wave network.
2.  Once the controller is ready to remove your device, press the manual/program button(A) on the smart dimmer 3 times quickly.
   To Return The Device To Factory Defaults:
   Manual: Click the button 2 times quickly then hold for at least 10 seconds
   Host reset: Remove it from the host connection and the device will factory reset

Association Group:
Group 1 supports 1 node ID. Group 2 Supports up to 5 node IDs.
Association group_1: Z-Wave Plus Lifeline Association Group 2: Send Basic Set ON/OFF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>