AKO-57614 Universal Detectors Instruction Manual

AKO-57614 Universal Detectors

Product Information

• Product Model: AKO-5761x
• User Manual Edition: 5532H631 Ed.03
• Revision: 355532631 REV.02 2023
• Languages: Spanish (es), English (en), French (fr), German (de), Portuguese (pt)

Product Usage Instructions:

1. Drilling and Mounting:

   • For cable entry, drill a 16 mm hole in the lower area and attach the supplied cable gland.
   • Use the provided template to mark the fastening holes on the wall.
   • Drill the marked holes and then attach the pushbutton using the supplied screws and wall plugs.
   • Note: If attaching to the wall of a cold room, do not use the wall plugs.
   • The pushbutton must be located no more than 1.25 m from the ground, positioned horizontally, and in a visible location inside the cold room.

2. Cable Installation:

   • Insert the cable through the gland and tighten it.

   • Strip and cut the cable sheath to ensure that the wires arrive
     at the connector strip without tension.

   • Install the connector tips on the ends of the three wires.

   • Connect the wires according to the installation diagram.

3. Important Note:

   • Do not use silicone or other sealants to close openings.

Installation of detectors

WARNINGS

• For installation inside refrigeration chambers, always use UNIVERSAL (AKO-57614) type detectors. 2 -Use type V3V3-fr cables with three 0.5 mm conductors. Insulation voltage must be 300/500 V.
• Do not install the detector or button near areas where ice or condensation could form (evaporators, doors, etc.).
• Drill a 16 mm hole in the lower area for cable entry and attach the supplied cable gland.
• Use the template provided to mark the fastening holes on the wall, drill them and then attach the pushbutton using the screws and wall plugs supplied. If attaching to the wall of a cold room, do not use the wall plugs.
• The pushbutton must be located no more than 1.25m from the ground, positioned horizontally, and must be in a visible location inside the cold room.
• Insert the cable through the gland and tighten it.
• Strip and cut the cable sheath so that the wires arrive at the connector strip without tension.
• Install the connector tips on the ends of the three wires.
• Connect the wires according to the installation diagram.
• Close the detector.
• The cable must make a 180 º bend after exiting from the bottom of the detector (as seen in the image) to prevent water from reaching the wires.

IMPORTANT

• Do not use silicone or other sealants to close openings.

AKO ELECTROMECÁNICA , S.A.L.

• Avda. Roquetes, 30-38
• 08812
• Sant Pere de Ribes.
• Barcelona
• Spain.
• www.ako.com.

We reserve the right to supply materials that might vary slightly to those described in our Technical Sheets. Updated information is available on our website.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>