LiftMaster CSW200501UL AC High Traffic 1-2 Hp Swing Gate Operator User Manual

LiftMaster CSW200501UL AC High Traffic 1-2 Hp Swing Gate Operator

Product Information

• Model: CSW200501UL
• Power: 1/2 HP
• Repair Parts:
  • Plastic Standoffs for main control board (10 per bag)
  • Reset Button with ID
  • Hall Effect Sensor Board
  • Wire Harnesses:
  • Main board to power board
  • Main board to ground
  • Main board to transformer
  • Power board to transformer
  • Wire Harness (main board to expansion board)

Product Usage Instructions

1. Ensure the power supply is disconnected before performing any repairs or adjustments.
2. If any of the plastic standoffs for the main control board are damaged or missing, replace them with the provided ones. Each bag contains 10 standoffs.
3. If the reset button is not functioning properly or shows signs of damage, it can be replaced with the included reset button with ID.
4. If the hall effect sensor board is faulty, it needs to be replaced. Contact customer support for further assistance.
5. For wire harness replacements, follow these steps:
   • Main board to power board:
   1. Locate the wire harness connecting the main board and power board.
   2. Carefully disconnect the existing wire harness.
   3. Connect the new wire harness between the main board and power board.
   • Main board to ground:
   1. Locate the wire harness connecting the main board and ground.
   2. Carefully disconnect the existing wire harness.
   3. Connect the new wire harness between the main board and ground.
   • Main board to transformer:
   1. Locate the wire harness connecting the main board and transformer.
   2. Carefully disconnect the existing wire harness.
   3. Connect the new wire harness between the main board and transformer.
   • Power board to transformer:
   1. Locate the wire harness connecting the power board and transformer.
   2. Carefully disconnect the existing wire harness.
   3. Connect the new wire harness between the power board and transformer.
   • Main board to expansion board:
   1. Locate the wire harness connecting the main board and expansion board.
   2. Carefully disconnect the existing wire harness.
   3. Connect the new wire harness between the main board and expansion board.
6. If you encounter any difficulties during repairs or have any questions, please contact our customer support team for assistance.

REPAIR PARTS

NOT SHOWN

Plastic Standoffs for main control board (10 per bag)| K77-37683
Reset Button with ID| K94-37449
Hall Effect Sensor Board| K1D8247
Wire Harnesses (main board to power board, main board to ground, main board to transformer, and power board to transformer)| K77-37693
Wire Harness (main board to expansion board)| K94-34778

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>