AWOLIMEI M1 GPS Speed Meter User Manual

AWOLIMEI M1 GPS Speed Meter

Warning: product working voltage is 5V, and it is forbidden to use a voltage higher than5Vforpower supply.

Display functions

1. Light sensor: HUD can automatically adjust the brightness according to the environment
2. Satellite icon: After the satellite is found, it stops flashing and goes out before it can be used normally
3. Compass: N (North) E (East) W (West) S (South)
4. Buzzer
5. Vehicle speed display : display the current vehicle speed
6. Speed unit: MPH- mile, KM/H- kilometer
   

Button functions

Short press (1 second)
Long press 5s until the display image comes

1. Short Press
   To switch vehicle speed, satellite number, enter into menu setting to switch menu options or parameter values
   Long Press
   To enter into menu settings (see instructions for Menu 1-6) and press 5 seconds to save and exit

2. Short Press
   After entering the settings, Menu – and parameter value –
   Long Press
   To turn on and off the buzzer (default choice is buzzer on,you can freely choose to turn on or off)

3. Short Press
   After entering the settings, Menu + and parameters value +
   Long Press
   The screen is all on, and the fault code is eliminated, long press again to exit

4. Power switch
   Long press for 5s to turn off, again to turn on

5. OBD connection port

Enter setting

Long press the to enter setting, short press choose menu, short press to confirm, long press after adjustment to save and exit

Menu| Function| Range| Explanation| Default value| Setting screen
---|---|---|---|---|---
| Speed| 50-150| Adjust the parameter value when there is an error between HUD and dashboard.
Ex: dashboard displays 100 KM, HUD displays 105 KM. Please adjust the parameter value to 102.(107-5)| 107|
| Over speed alarm| 30-250| Over speed alarm is 150KM / H, users can freely set this value| 150|
| Fatigue Driving Reminder| 1.0-8.0| Fatigue driving reminder is 4 hours| 4.0|
| Brightness level| 0-11| 0-automatic photosensitive mode 1-11 is manual adjustment| 0|
****| Speed unit| 0-1| 0=KM

1=MPH

| 0|
| Factory reset| 0-1| The default value is 0. After adjusting to 1, long press to save and exit.| 0| ****

GPS display FAQ

1. The screen without any display, and no power
   Check whether the USB cable is damaged, replace the USB cable for testing, and prohibit the use of voltage higher than 5V for power supply

2. Without car Speed
   After HUD power-on, the satellite icon flashes will start to find the satellite. Please driving the car to the road. It will work after it stops flashing

3. Inaccurate Speed
   a. First check the speed unit is correct or not, the speed unit including KM/H and MPH, please refer to the setting to switch the unit.
   b. The car manufacturers usually make the dashboard speed 5-7% higher than the ECU. The international standard is based on satellite data. (if the dashboard shows 100, and the device shows the 105, change the default value at

4. Driving direction display error
   After the vehicle speed exceeds 5KM / H, the direction can be displayed normally.

5. Speed is still displayed after the car stops
   Under the underground parking lot, tunnel, under the overpass, there will be unstable satellite drift when there is obstruction.

6. Turn off the buzzer
   Push left for 2 seconds to turn off the buzzer, do it again to turn on.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>