carmanah MX Series Push Button Kit Installation Guide
- June 12, 2024
- carmanah
Table of Contents
MX Series
PUSH BUTTON KIT INSTALL GUIDE
LEVEL 4
MX Series Push Button Kit
NOTE
ADA regulations specify that the button should be 42″ from the ground.
NOTE
Push button can be connected in either polarity.
NOTE
Two or fewer parallel-connected buttons recommended per module trigger
input.
- Prepare pole and install button base per button manufacturer’s instructions.
- Ensure cable entry hole is deburred and button base sits flush against pole.
- Fish cable through pole and button base and slip gasket over cable.
- Connect one wire to each button terminal (button is not polarized).
- Install button with its supplied hardware, ensuring gasket is in place and cable forms a drip loop inside pole.
- Connect other end of cable to trigger input terminals A and B of any power or flasher module.
- Secure cable with cable tie following power or flasher module instructions.
NOTE: READ ALL INCLUDED INSTALL GUIDES BEFORE SYSTEM INSTALLATION
Carmanah Technologies Corp.
250 Bay St, Victoria, BC V9A 3K5, Canada
1.250.380.0052
customersupport@carmanah.com
carmanah.com
References
- Systems for Traffic Beacons and Signs | Solar LED Beacons | Carmanah
- Systems for Traffic Beacons and Signs | Solar LED Beacons | Carmanah
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>