ALLIED BATTERY 51105-5303 51.2V 105Ah Lithium Iron Phosphate Battery User Guide
- June 12, 2024
- ALLIED BATTERY
Table of Contents
ALLIED BATTERY 51105-5303 51.2V 105Ah Lithium Iron Phosphate Battery
Product Information:
- Product: 12V DC-DC Converter
- Wire Colors and Gauges:
- ORANGE: 16AWG
- YELLOW: 16AWG
- RED: 16AWG
- BLACK: 16AWG
- Components:
- Cart Accessories
- B Motor Controller
- Solenoid
- Battery Charger
- Battery Type: Commercial Lithium
Battery Connection
Product Usage Instructions:
- Begin by connecting the ORANGE wire to the switched B+ power source, unless you require constant power for upgraded accessories.
- Ensure that the cable rings have solid flush contact with the battery terminal.
- Attach the largest diameter (high current) cables to the battery terminals first to minimize resistance.
- Refer to the user manual or consult a professional for specific application, service, or installation details as they may vary from case to case.
- Always handle the battery with caution and follow safety precautions, including avoiding sources of static electricity.
- Keep chargers off while working on batteries and never attempt to open the battery.
- Avoid actions that can damage the battery, such as puncturing, dropping, crushing, burning, penetrating, shaking, hammering, or misconnecting terminals.
- If you have any questions or need assistance with the battery installation or usage, contact Allied’s technical support engineers through the provided phone numbers or website.
BEGIN SAFE TO END SAFE
- Always wear proper personal protective equipment (PPE).
- Never wear jewelry or other metal objects when working on or around batteries.
- Always use insulated tools when working on batteries.
- Never place objects on top of batteries.
- Always check connections for proper torque.
- Proper connections should be checked regularly to ensure a tight connection.
- Never charge a battery when the temperature is below 32°F or above 131°F.
- Always keep sparks and flames away from batteries. (including sources of static electricity)
- Never store batteries below 30% State of Charge.
- Always use Allied lithium charger
- Always make sure chargers are off or disconnected while working on batteries.
- Never attempt to open the battery case.
- Always install in a parallel set up.
- Do not immerse in the battery in water.
- Never over-charge or over-discharge the battery.
- Never attempt to connect batteries in series.
INSTALLING ALLIED BATTERIES
- Use hand tools only and ensure the cable rings have solid flush contact with the battery terminal; largest diameter (high current) cables attach to battery terminals first for lowest resistance.
- Take a photo of the battery wiring in the cart before removal.
- Take note of the wires attached to the system positive and system negative.
- Lead-Acid batteries are wired in Series, Allied batteries are wired in Parallel. Common cart voltages include 36V (38.4V) / 48V (51.2V) / 72V (76.8V)
- Please confirm all Allied batteries are the same voltage and match your motor/controller system voltage.
- Remove Lead-Acid Batteries and install Allied batteries.
- Parallel Batteries make common connections only.
- Positive (red) only connects to positive, Negative (black) only connects to negative. Parallel Batteries must match cart controller voltage (24V/36V/48V/72V)
- Do not connect parallel batteries in series to protect from high voltages which will destroy electronics, and can cause personal injury.
- Parallel connections increase Amp-hour capacity (3x 30Ah = 90Ah; 5x 36Ah = 180Ah).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>