Bel Air Lighting 51404 Pendant Light Chain Instruction Manual
- June 12, 2024
- BEL AIR LIGHTING
Table of Contents
51404 Pendant Light Chain
Instruction Manual
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
STEP 1
Attach the end of the chain to the loop on the fixture.
STEP 2
Use the mounting screws to attach the mounting unit to the junction box
STEP 3
Pass the chain and the branchwires through the screw collar ring and canopy.
Feed the branchwires through the pipe nipple on the mounting unit and attach
the end of the chain to the mounting unit.
STEP 4
Make the electrical connection from the junction box to the fixture. Connect
the ground wire to the mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative andground wires with the supplied
wire nuts. Secure with electrical tape
Connect Clear, Brown, Gold or Black Parallel Wire without tracer (round &
smooth) or Black Fixture Wire to:
Black or Red Supply Wire or Insulated Wire (other than green) with copper
conductor.
Connect Clear, Brown, Gold or Black *Parallel Wire with tracer (square &
ridged) or White Fixture Wire to:
White Supply Wire or Insulated Wire (other than green) with silver conductor
STEP 5
Secure the canopy to the mounting unit with the screw collar ring.
STEP 6
Place the glass on the socket and secure it with socket ring.
Install the bulb E26 6OW MAX(not included).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>