Bel Air Lighting PND-2206 AG Ludlow 1 Light Antique Gold Hanging Kitchen Pendant Light Instruction Manual
- October 30, 2023
- BEL AIR LIGHTING
Table of Contents
PENDANT LIGHT (ROD)
Assembly Instructions
MODEL#ADND-2206
CAUTION
- Inspect the wire insulation for-any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
Assembly
STEP 1
Screw the rods to the fixture. Make sure to feed the branch wires of the
fixture through the rods during assembly. Remove or add rods to adjust the
height. 
STEP 2
Use the mounting screws to attach the mounting unit to the junction box
STEP 3
Make the electrical connection from the junction box to the fixture. Connect
the ground wire to the mounting unit using the preinstalled green ground
screw, Then, connect the positive, negative and ground wires with the supplied
wire nuts. Secure with electrical tape.
STEP 4
Place the canopy over the mounting unit and secure the fixture with the cap
nuts.
STEP 5
Install bulb(Not inciuded)and Install glass
E26 TYPE A 60W
STEP 6
Slide the metal cover down and tighten the nut
STEP 7
The installation is complete
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>