Bel Air Lighting 51394 Kingsbury 1-Light Black Outdoor Hanging Pendant Light Instruction Manual
- June 12, 2024
- BEL AIR LIGHTING
Table of Contents
51394 Kingsbury 1-Light Black Outdoor Hanging Pendant Light
Instruction Manual
HANGING LANTERN
Assembly Instructions
Model:51394
51394 Kingsbury 1-Light Black Outdoor Hanging Pendant Light
CAUTION
- Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have resulted during shipping. If there is a defect in the wire, do not attempt installation.
- Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
TOOLS REQUIRED
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
STEP 1
Attach the end of chain to the loop on the canopy and the loop on the fixture.
Pass the branch wires through the chain and the nipple on the canopy. 
STEP 2
Use the mounting screws to attach the mounting unit to the junction box STEP
3
Make the electrical connection from the junction box to the fixture. Connect
the ground wire to the mounting unit using the preinstalled green ground
screw. Then, connect the positive, negative and ground wires with the supplied
wire nuts. Secure with electrical tape
Connect Clear, Brown, Gold or Black
Parallel Wire without tracer (round & smooth) or Black Fixture Wire to:
Black or Red Supply Wire or Insulated Wire (other than green) with copper
conductor.
Connect Clear, Brown, Gold or Black *Parallel Wire with tracer (square &
ridged) or White Fixture Wire to:
White Supply Wire or Insulated Wire (other than green) with silver
conductor
STEP 4
Place the canopy over the mounting unit and secure it with the cap nuts.
STEP 5
Place the glass on the socket and secure it with socket ring.
Install the bulb E26 60W MAX(not included).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>