wallbox P1 Pulsar Plus Port Metering Solution Installation Guide
- June 12, 2024
- wallbox
Table of Contents
wallbox P1 Pulsar Plus Port Metering Solution Installation Guide
How to install P1 Port
-
Depending on the country, the P1 port can be already activated or not. Contact the utility company to check the status and proceed with the activation when needed.
-
Fix the P1 Port meter to the DIN Then, connect the RJ12 connector to the utility meter and the Wallbox
-
Look at the diagram to check how to wire P1 Port to a charger
Disclaimer
The P1MB is connected via an RJ12 connection to the P1 Port. The device is
powered by the +5V of the P1 Port of the connected smart meter. If not
available, the P1MB can optionally be powered by an\
Once the installation is completed and the charger is configured, check the P1 Port’s led lights:
Power Status Led – Yellow
If the yellow light is on, the P1 Port is powered, while the device is not powered, in case the led is off.
P1 Status Led – Green
If the green light is on, P1 data was received with the correct CRC.
If it is off, no P1 data was received from the smart meter within the last
minute.
c
Disclaimer
Wallbox does not allow splitters on the connection. For this reason, if another hardware is connected to the P1, we recommend other alternatives for the Power Boost meter (Wallbox EM112, Wallbox N1 CT, Wallbox EM340 or Wallbox EM330).
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>