Roll Hill Modo Sconce – 2 Globe Wall Lamp Instruction Manual
- June 12, 2024
- Roll Hill
Table of Contents
Roll Hill Modo Sconce – 2 Globe Wall Lamp
Product Information
The Modo Sconce – 2 Globe is a wall-mounted light fixture that comes with two globes, a crossbar, bulbs, junction box screws, a Wago connector, a long 8-32 screw, a toggle anchor, wood screw, and a metal screw. The fixture is available in both 120V LED G25 E26 and 240V LED G25 E27 bulbs, which are included in the package. The fixture is designed to be installed on the wall and is suitable for indoor use only.
Product Usage Instructions
To install the Modo Sconce – 2 Globe on the wall, follow the instructions below:
- Before installation, ensure that the power supply to the fixture is turned off.
- Attach the crossbar to the junction box using the provided screws.
- Connect the wires from the junction box to the Wago connector provided with the fixture.
- Attach the fixture to the crossbar using the long 8-32 screw provided with the fixture.
- Attach the toggle anchor provided with the fixture to the wall (on 240V fixtures only).
- Attach the wood screw provided with the fixture to the wall (on 240V fixtures only).
- Attach the metal screw provided with the fixture to the wall (on 240V fixtures only).
- Attach the globes to the socket fitter and cap provided with the fixture. To do so, sandwich the glass globe around the socket fitter and cap and gently tighten the sleeve to hold the globe in place.
- Turn on the power supply and test the fixture to ensure it is working properly.
Note: For 240V fixtures, follow the additional instructions provided with the toggle anchor, wood screw, and metal screw to ensure proper installation.
CONTENTS
WALL INSTALLATION
MODO SCONCE – 2 GLOBE
Note: Please contact a licensed electrician.
Note: Do not use bulbs that exceed 25 watts.
- Attach custom crossbar (A) from the back of the fixture onto the junction box using provided #8-32 screws (B). Level the crossbar so that two of the holes are horizontal. Pull electrical wires out through the crossbar.
- Trim excess wire and make electrical connections from the junction box to the sconce (C). For 240V, connect the copper ground wire from the fixture to the green ground wire (E). Push the connected wires back through the center hole of the crossbar.
- Fit the fixture over the crossbar and secure in place with provided 8-32 screws into the crossbar (D).
INSTALLATION | ATTACHING MODO GLOBES
- Sandwich the glass globe (A) around the socket fitter (B) and cap (C). Gently tighten the sleeve (D) to hold the globe in place.
- T +1 718 387 6132 www.rollandhill.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>