Roll Hill MODC3 3 Sided Chandelier 10 Globes Instruction Manual

Table of Contents

Roll-Hill-MODC3-3-Sided-Chandelier-10-Globes-PRODUCT

Only one light bulb per socket.
Only suitable for direct mounting on non-combustible surfaces.
Under no circumstances can Modo Chandeliers be mounted on normally flammable surfaces.
Suitable for dry, indoor use only.
Maximum ambient temperatures: 25˚ C

Note: Please contact a licensed electrician.

To measure length of the stem, first determine the overall length (OAL), subtract 1” from the canopy height, and subtract the fixture height from the OAL. Fixture height is measured from the bottom of the fixture to the stem connection point.
The resulting measurement is the final stem length.
Ex. The fixture below has an OAL of 40” and a fixture height of 19”. 40” OAL – 1” canopy – 19” fixture height = 20” stem

Note: Please contact a licensed electrician

Example fixture only:

To customize the length of the provided stem, cut the cover tube to the desired length. Then cut the inner threaded tube so that it remains 1/2” longer than the cover tube
Mark the length of the tube required, using a marker or tape. Then hold down the tube with a hand or a clamp, and use a hacksaw or electrical tool to cut the tube. Recommended to clean the tube after cutting to remove any metal chippings.
Now that the cover tube is cut to 20”, measure the all thread tube to be 20 and 1/2” long. And place a mark, with a marker or tape.
Hold down the all-thread with a hand or a clamp, and use a hacksaw or electrical tool to cut the all-thread tube. Recommended to clean all thread tubes after cutting to remove any metal chippings.

MODO

Note: Please contact a licensed electrician.
Note: Do not use bulbs that exceed 25 watts.

Install the crossbar (A) using #8-32 screws to junction box (B) in the ceiling.
Attach the green ground wire (for 240V, attach the copper ground wire from the fixture) to the crossbar with ground screw (C).
Once the crossbar is secure, screw the threaded inner tube (D) a quarter inch into the center hole. Feed the wires from the bottom of the threaded tube into the junction box, strip wires, and make electrical connections.
Conceal wires and connections inside the junction box.
Slide the canopy (E) up the threaded tube to the ceiling, followed by the cover tube (F).
Screw the half hub (G) onto the bottom of the all-thread rod. This will tighten the canopy flush to the ceiling.
Carefully lift the fixture so that the two half-hubs align. Cut excess wire, strip ends, and make electrical connections between the stem and the fixture (H). For 240V, connect the copper ground wires with butt splice (I) Tuck all wires inside the hub and close them.
Note: This step requires two people
Secure the two half hubs together using a hex key and the provided #6-32 socket screws on either side.

ATTACHING MODO GLOBES

Sandwich the glass globe (A) around the socket fitter (B) and cap (C). Gently tighten the sleeve (D) to hold the globe in place.

| Roll Hill MODC3 3 Sided Chandelier 10 Globes [pdf] Instruction Manual
MODC3, 3 Sided Chandelier 10 Globes, 10 Globes, 3 Sided Chandelier, Chandelier
---|---